Black & Decker D28499, D28494, D28497, D28493 manual Sanding Flap Discs, Accessories and Attachments

399080-02 rev 11/15/02 10:13 AM Page 5

MULTIPLE SIDE HANDLE POSITIONS

Sanding Flap Discs

The side handle can be properly positioned in five locations based on personal preference and application. The side handle must be used at all times to maintain proper control of the tool.

RUBBER BUMPER

The gear case rubber bumper may wear with use. The bumper can be replaced with part number 397711-00 available at extra cost from DEWALT authorized service centers. Replacement should be performed by DEWALT authorized service centers or qualified service personnel.

SPINDLE LOCK	C
The spindle lock pin is provided to prevent the
spindle from rotating when installing or removing
wheels. Operate the spindle lock pin only when
the tool is turned off and unplugged from the
power source. To engage the lock, depress the
spindle lock button (C) and rotate the spindle
until you are unable to rotate it further.

CAUTION: Never depress the spindle lock button while the grinder is running. Never turn on the grinder while the spindle lock button is depressed. Damage to your tool or personal injury may result.

SOFT MOUNT

The grinder is equipped with a soft mount, enabling easy wheel installation and removal.

Accessories and Attachments

soft mount

Type 27 guard

D284937/D284939

hubbed sanding flap

disc

soft mount

Type 27 guard

D284937/D284939

backing flange

54339-00

non-hubbed sanding

flap disc

clamp nut 22191-00

English

It is important to choose the correct guards, backing pads and flanges to use with grinder accessories. See the chart on pages 5–7 for information on choosing the correct accessories.

NOTE: Wheel size must match guard size; i.e., a new 7" wheel may not be used with a 9" guard. The bottom surface of wheel must be inside the bend of the guard lip.

5