BM 2610018532
The undertable base accessory includes the screws needed to fasten the base to a router table mounting plate, as well as a
ATTACHING BASE TO
MOUNTING PLATE
Attach the RA1161 to the router table’s mounting plate using either or both sets of enclosed mounting screws.
The base has two sets of threaded holes for mounting the base:
•Three
•Four M4 holes in Bosch
Mounting screws required for the RA1161: (not included with all models).
•Three
•Four M4 screws.
The length will depend on the thickness of your router table or router table mounting plate.
If your router table mounting plate does not have countersunk holes in either of those patterns, you will need to determine the hole locations, drill and countersink them, also locate and drill a hole for the
CONNECT THE ROUTER AND THE
ROUTER TABLE SWITCH To prepare for use of the switch,
1.Make sure the router switch and the router table switch are both turned off.
2.Plug the router table switch cord to wall outlet.
3.Plug the router into the "pigtail" socket on the router table switch.
4.Lock router switch on: squeeze trigger, depress
5.Use the router table switch to start and stop the router.
DEPTH ADJUSTMENT (See page
FEEDING THE WORKPIECE
ON A ROUTER TABLE
Always use your router table's fence or starter pin and the appropriate guard and follow the router table's instruction manual. ALWAYS feed the workpiece from right to left across the front of the bit. On Bosch router tables, the correct feed direction is also shown on fence housing and on the featherboards, when they have been properly installed. (Fig. 29)
Whenever possible, when using the fence, use a push stick to push the workpiece, especially when working with narrow pieces.
For complete instructions on operation of a router in a router table, please refer to the instructions that come with the router table.
TOP VIEW
NOTE: For clarity, guard and featherboard removed from drawing.
FIG. 29
DIRECTION
OF FEED
FENCE FACE | FENCE FACE |