Schumacher SCI90 Troubleshooting, Problem Possible Cause Solution, Connected, Charging

Page 10

Troubleshooting

PROBLEM		POSSIBLE CAUSE		SOLUTION
CONNECTED	LED is	The battery is not connected	Check for proper connection to
not on.		correctly.	the battery.
not on.
		Battery voltage is at zero volts.	Turn off everything in the car
			and try to connect again.
		Input fuse is bad.	Replace the fuse (5 Amp fuse).
		Output breaker is bad.	Push button to reset the breaker.
CHARGING	LED is	Charger is in Abort Mode.	Unplug the charger from the
blinking.			AC and plug it back in.
		Battery is sulfated.	Use	(Desulfation Mode) for
			8 hours.
		Battery is bad.	Have the battery checked.
FULL CHARGE	LED	Surface charge voltage is high.	Replace the battery.
is on, but battery is not		Battery voltage is very low and	Unplug the charger from the
fully charged.		Battery voltage is very low and	Unplug the charger from the
		the charger detects it as 6V,	AC and plug it back in.
		not 12V.
All LEDs are lit in an		A button may have been	Unplug the charger from the
erratic manner.		pressed while the charger was	AC and plug it back in, without
		being plugged in.	touching the control board.

• 10 •

Image 10

Contents SCI90 Important Safety Instructions Save These Instructions Model SCI90Personal Precautions Follow These Steps When Battery is Outside Vehicle Follow These Steps When Battery is Installed in VehicleCharger Location Control Panel Grounding and AC Power Cord ConnectionsBattery Type/Mode Button Charge Rate ButtonOperating Instructions Maintaining a Battery 3A Charge Rate Desulfation ModeMaintain Mode Using the Engine Start featureMaintenance Instructions Using the Battery Voltage TesterUsing the Alternator Performance Tester Engine Starting NotesError Description Cause Code SpecificationsTroubleshooting and Error Codes Error Codes Moving and Storage InstructionsConnected TroubleshootingProblem Possible Cause Solution ChargingPage Declaration of Conformity Wichtige Sicherheitshinweise Diese Anleitung Aufbewahren Achtung STROMSCHLAG- Oder BrandgefahrAchtung Gefahr Explosiver Gase Page Page Ladegeschwindigkeitstaste BedienfeldBatterietyp-/Modustaste Batteriedaten DigitalanzeigeBedienungsanleitung AufladenDesulfatierungsmodus Automatischer LademodusLadevorgang abgebrochen Abschluss des LadevorgangsHinweise zum Motorstart Verwenden der Motorstart-FunktionVerwenden des Batteriespannungsprüfers Wartungsanleitung Verwenden des Lichtmaschinen-SpannungsprüfersTransport UND Lagerung Fehlersuche UND Fehlercodes Fehlercodes Technische DatenFehlercode Beschreibung Ursache Fehlersuche Problem Mögliche Ursache AbhilfeAngeschlossen Hoopeston, USA -800-621-5485 services@schumacherelectric.com Konformitätserklärung Modelo SCI90 Advertencia Riesgo DE Descarga Eléctrica O FuegoAdvertencia Riesgo DE Gases Explosivos Page Botón para seleccionar capacidad de carga Instrucciones DE Funcionamiento Tipo de batería / Botón seleccionar Modo de cargaPantalla digital Información de bateríaModo automático de carga Defectos del arranqueIndicador de conexión de batería Carga interrumpidaNotas sobre el arranque del motor Utilizar la función de encendido de motorDE Arranque DEL Motor Utilizar el probador de tensión de bateríaInstrucciones DE Almacenamiento Y Movimiento Utilización de un probador de rendimiento del alternadorInstrucciones DE Mantenimiento EspecificacionesLocalización y Solución de Problemas Código Descripción RAZÓN/SOLUCIÓN ErrorLA LUZ LED Carga Completa Declaración DE Conformidad Consignes DE Sécurité Importantes Conserver CES Consignes Avertissement Risque DE Choc Électrique OU D’INCENDIEAvertissement Risque DE GAZ Explosifs Page Panneau DE Contrôle Bouton Taux de chargeConsignes D’UTILISATION Type de batterie / Bouton ModeAffichage numérique Informations sur la batterieMode Entretien Mode de chargement automatiqueMode de désulfatation Indicateur de connexion de la batterieUtilisation du testeur de tension de batterie Instructions DE Transport ET Stockage Tester la performance de l’alternateurConsignes D’ENTRETIEN CaractéristiquesDépannage Code Description Raison / Solution ’ERREURDepannage ET Codes D’ERREUR Codes d’erreur LED ConnectéeCharge Complète Déclaration DE Conformité