HP MSL6000 manual Ensure Scsi options are set correctly

Table 10 Fault Symptom Codes (continued)
FSC	Message	ERP
0B02	Public Ethernet Set IP Error	• Make sure a valid Ethernet address has
	(The library could not set the IP	been programmed using the LCD touch
		display. (Menu -> Maintenance ->
	parameters)
		Library)
		• Reboot the library
1001	SCSI Firmware Error	• Turn off power to the library and inspect
	(Internal SCSI task processing error.	connectors and cables.
		• Check the SCSI cable connections to
	Unexpected state or hardware status.)
		make sure they are secured.
		• Make sure the library controller board
		has SCSI termination.
1002	SCSI FIFO Empty	• Turn off power to the library and inspect
	(The SCSI controller data FIFO is empty	connectors and cables.
		• Check the SCSI cable connections to
	but should contain more data bytes.)
		make sure they are secured.
		• Make sure the library controller board
		has SCSI termination.
1003	SCSI FIFO Error	• Turn off power to the library and inspect
	(The SCSI controller data FIFO should be	connectors and cables.
		• Check the SCSI cable connections to
	empty but still contains data bytes.)
		make sure they are secured.
		• Make sure the library controller board
		has SCSI termination.
1004	SCSI Gross Error	• Turn off power to the library and inspect
	(The SCSI controller detected a gross error	connectors and cables.
		• Ensure SCSI options are set correctly.
	condition. Invalid SCSI bus phase or
	DMA error.)	• Check the SCSI cable connections to
		make sure they are secured.
		• Make sure the library controller board
		has SCSI termination.
		• Check host SCSI cable and connections.

104 Troubleshooting