Table 5 View Library Options (continued)
Option | Description |
Drive and Slot Numbering | Lets you specify whether SCSI elements in the library displays |
| with either zero based or one based. Note that this only affects |
| the GUI touch screen, not the actual SCSI element addresses. The |
| default is Zero Based. |
|
|
Library Mode | Lets you set the robotics operating mode to Random, Sequential |
| Drv0, Sequential Drv n (two or more drives), or Sequential Split. |
| Sequential Drive n and Sequential Split require two or more |
| drives in the library. Sequential mode is not available with |
| |
|
|
Sequential Mode | Sequential Mode is locally controlled. Sequential operations |
| begin with any cartridge loaded into Drive 0. The library |
| monitors the drive status, and when the host unloads a cartridge |
| from the drive, it returns the cartridge to the magazine, and then |
| loads the next cartridge in magazine numerical order. This |
| operation continues until all cartridges have been loaded, or |
| until an empty slot is encountered. Two options are available: |
| Normal (same as Library Mode above) and Recirculate. Instead |
| of stopping after the cartridge in the last slot for the drive has |
| been unloaded by the host, Recirculate mode continues the |
| operation by loading the first cartridge for the drive. |
| Recirculation will continue until an empty slot is encountered, or |
| the operator unloads the tape using the GUI touch screen. |
|
|
LCD Contrast Adjust | The LCD contrast controls let you increase or decrease the |
| contrast of the LCD display. The incremental steps are set by |
| adjusting the LCD Contrast Adjust option from the Library option. |
| Incremental steps can range from 0 to 31 depending on your |
| preference. The default is 16. |
|
|
| Lets you enable or disable the mail slot(s) in a library. For the |
| |
| |
|
|
Barcode Label Size | Lets you limit the length of the bar code label. Possible settings |
| are 1 through 8. The default is 8. |
|
|
Barcode Label Assignment | Lets you specify the alignment of a bar code label. The options |
| are Left or Right. When used in conjunction with the Barcode |
| Label Size option, this option strips unwanted trailing characters |
| (left alignment) or leading characters (right alignment). The |
| default is Left Align. |
|
|
Barcode Label Check Digit | Lets you specify whether to enable or disable the verification of a |
| check digit character in the bar code label. The default is |
| Disabled. |
|
|