HP MSL6000 manual Fsc

Table 10 Fault Symptom Codes (continued)
FSC	Message	ERP
307A	Diag get drive 2 status failed	•	Press the Enter button to reboot.
	(Failed to get drive status, communication	•	Ensure the drive shows good status
	error.)		through the drive status window.
		• Deactivate the drive using the GUI control
			panel maintenance menu.
		•	Reseat drive.
		•	Check cabling.
		• Load/unload a cartridge to the drive to
			verify.
		• Check the tape cartridge used in the last
			operation for damage.
		• Run the cartridge cycle diagnostic to
			verify.
307B	Diag get drive 3 status failed	•	Press the Enter button to reboot.
	(Failed to get drive status, communication	•	Ensure the drive shows good status
	error.)		through the drive status window.
		• Deactivate the drive using the GUI control
			panel maintenance menu.
		•	Reseat drive.
		•	Check cabling.
		• Load/unload a cartridge to the drive to
			verify.
		• Check the tape cartridge used in the last
			operation for damage.
		• Run the cartridge cycle diagnostic to
			verify.
3082	Drive Stow Failed, Media Returned to	•	Press the Enter button to clear the
	Source		message.
		• Use only media approved for the drive
			type.
		• Invalid user initiated operation. Set
			parameters correctly and try again.
3083	Drive Stow Failed, Media Remains in	•	Press the Enter button to clear the
	Drive		message.
		• Invalid user initiated operation. Set
			parameters correctly and try again.
		• Ensure cartridges are in magazines.

MSL6000 series tape library user guide 119