HP MSL6000 manual Fsc

Table 10 Fault Symptom Codes (continued)
FSC	Message	ERP
3078	Diag get drive 0 status failed	•	Press the Enter button to reboot.
	(Failed to get drive status, communication	•	Ensure the drive shows good status
	error.)		through the drive status window.
		• Deactivate the drive using the GUI control
			panel maintenance menu.
		•	Reseat drive.
		•	Check cabling.
		• Load/unload a cartridge to the drive to
			verify.
		• Check the tape cartridge used in the last
			operation for damage.
		• Run the cartridge cycle diagnostic to
			verify.
3079	Diag get drive 1 status failed	•	Press the Enter button to reboot.
	(Failed to get drive status, communication	•	Ensure the drive shows good status
	error.)		through the drive status window.
		• Deactivate the drive using the GUI control
			panel maintenance menu.
		•	Reseat drive.
		•	Check cabling.
		• Load/unload a cartridge to the drive to
			verify.
		• Check the tape cartridge used in the last
			operation for damage.
		• Run the cartridge cycle diagnostic to
			verify.

118 Troubleshooting