HP MSL6000 manual Magazine in the master module

Table 10 Fault Symptom Codes (continued)
FSC	Message	ERP
8002	Drive Fan stalled	• Press the Enter button to clear the
	(The fan in the drive hot-swap shoe is	message.
		• Look for a drive with an amber LED (rear
	either not installed or has stalled.)
		of library) to determine which drive has
		the fan issue. If the drive is not in use,
		take it off-line to prevent it from
		overheating. If currently in use, end the
		operation immediately, and take the drive
		off-line.
8003	Drive load did not complete	• Press the Enter button to reboot.
	(The drive failed to successfully load a	• Ensure the drive shows good status
	tape.)	through the drive status window.
		• Cycle power to the library or reboot
		using the GUI touch screen.
		• Check the tape cartridge used in the last
		operation for damage.
8004	Invalid drive was installed	• Press the Enter button to clear the
	(One or more installed drives are of a	message.
		• Update the firmware if a newer revision
	type either unknown or not supported in
	the current library personality.)	exists.
		• Invalid user initiated operation. Set
		parameters correctly and try again.
9001	Orphan cartridge recovery failed	• Make sure there is one empty slot in a
	(The master module could not successfully	magazine in the master module.
		• Press the Enter button to reboot.
	return an orphan cartridge to a slot
	location.)	• Cycle power to the library or reboot
		using the GUI touch screen.
		• Check pass-through alignment.
		• Ensure that there are no obstructions
		inside the library (all cartridges are in
		magazines).
		• Check the tape cartridge used in the last
		operation for damage.

132 Troubleshooting