HP General IO Connectivity manual Configuring System and Device Files for Uucp, At the dave system

PAD Services

UUCP Support (x29uucpd)

x3	Optional. This is the X.3 configuration set name for
	UUCP file transfers. If this entry is used in
	/etc/x25/x29hosts, the configuration set name with
	its set of X.3 parameters must be specified in
	/etc/x25/x3config. All legal X.3 parameters
	contained in the x3config file are downloaded at
	connection time. If there is more than one X.3
	configuration set with the same set name in
	/etc/x25/x3config, the first one is used.
	If there is no configuration set name in x29hosts or
	matching X.3 configuration set name in x3config, the
	default parameters are downloaded (see “X.3
	Parameter Descriptions” for information on X.3
	parameters). x29uucpd operates in line mode only.

		Configuring System and Device Files for UUCP
		The following example describes the configuration procedure for cu, uucp
		and uucico transfers between two systems. In this example, the local
		system is called “dave” and the remote system is called “bill.” The two
		systems are configured to handle file transfers originating from the local
		system (dave) and received by the remote system (bill).
NOTE		Refer to the man pages for information on x25uucp device entry
		parameters.
		At the “dave” system:
Step	1. Make sure that the directory /var/spool/uucp/LCK..x29 exists. If it
		doesn’t exist, create it.
Step	2. Configure the usr/lib/uucp/Systems file as follows:
		bill Any;5 dev_bill, f 19200 - ““ \r\d\r\d\r login: -BREAK
		-login: uucp word: test
		where:
		bill – is the name of the destination system (7 characters maximum).

154 Chapter 6