HP General IO Connectivity manual 222

Troubleshooting

Configuration and Troubleshooting Commands

		Because pvc describes a permanent circuit for a
		particular interface, that interface must have been
		initialized prior to the initialization of the address map
		table. If the interface or the specified PVC does not
		exist, an error is reported.
	prog_access
	_name	Specifies the card's programmatic access name.
NOTE		For Series 712 workstations this is always
		name=interface0.
	+URC	Specifies that outbound calls to this IP address will
		Use Reverse Charging (URC).
	-URC	(Default) Specifies that outbound calls to this IP
		address will not Use Reverse Charging (URC).)
	+ARC	Specifies that inbound calls to this IP address will
		Accept Reverse Charging (ARC).
	-ARC	(Default) Specifies that inbound calls to this IP address
		will not Accept Reverse Charging (ARC).

x25_card_device A device configured for one of your existing X.25 cards. This information is used by the IP_to_X25 software to identify the interface port through which the outbound packets will be sent.

CUG=n	Specifies the Closed User Group index number used for
	placing calls to this IP address. The index number is a
	two- or four-digit number. Two digits corresponds to the
	basic format, and four digits corresponds to the
	extended format of the CUG selection facility.
#	You can put comments in your IP mapping table by
	including the # character at the beginning of the line.
	Note that you cannot add comments after a table entry.

222 Chapter 8