HP General IO Connectivity manual Field Descriptions

Configuration

Configuring the X.25 Link

Table 3-1	Field Descriptions
	Configuration	Name of the file that will contain the parameters
	File name	for configuring the interface (a physical port). If
		you are configuring more than one interface,
		specify a unique configuration file for each
		interface.
		The configuration file must be named
		x25config_npx, where n represents the
		communications card number (use 0 for the first
		card, increasing the value by 1 for each additional
		card up to 255), p is a place marker, and x is the
		port number (1 to 4). Note that p and x are only
		required for systems with dual-port or quad-port
		cards.
	X.25 Address	Address assigned to each local X.25 interface
		(card or port) by the network carrier. X.25 checks
		it for diagnostic and identification purposes only.
		This address is sometimes referred to as the
		X.121 address. Use the value given on your
		subscription form.
	Programmatic	Name given to the interface you are configuring
	Access Name	(used for X.25 level 3 programmatic access).
	Network Carrier	Type of network to which the X.25 interface is
	Type	attached (as it appears on your subscription
		form). A complete list of possible networks is
		shown below. The default is DTE_84.
	X.25 Packet	This field appears (with its default value) only if
	Address	you select TRANSPAC as the Network Carrier
		Type.
	Network types
	You must select a Network Carrier Type that matches the type of
	network to which you are connected.

Chapter 3 35