Installation
Installing the X.25 Link Software
|
| Installing the X.25 Link Software |
|
| Follow the steps below to install the X.25 link software: |
Step | 1. | Insert the software media (tape or disk) in the appropriate drive. |
Step | 2. | Type: swinstall. |
|
| (See the man page on swinstall for more information on this |
|
| command). |
Step | 3. | Click on OK on the “Specify Source” window. |
Step | 4. | Highlight J2793B in the “Software Selection” dialog, then select Mark |
|
| For Install from the Actions menu to install all file sets in the bundle. |
|
| If you want to select only certain file sets, |
|
| name to access the file sets that you want to mark for installation (each |
|
| time you |
Step | 5. | When you have marked the product components you want to install, |
|
| select Install (analysis) from the “Actions” menu. |
Step | 6. | When you have successfully completed the analysis, click on OK from the |
|
| Analysis dialog to load the X.25 file sets. |
The swinstall utility loads the file sets, runs the customized scripts for the file set, and builds the kernel. Estimated time for processing: 8 to 10 minutes.
If the kernel build is not successful, the swinstall program returns you to a new shell. The cause of the failure will appear at the end of the /var/adm/sw/swinstall.log file.
Chapter 2 | 29 |