Heat & Glo LifeStyle ESC-42ST Ember/Mineral Wool Placement, Install Outer Refractory Panels

K. Ember/Mineral Wool Placement

WARNING! Risk of Explosion! DO NOT place embers directly over burner ports. Improperly placed embers inter- fere with proper burner operation. See instructions.

Ember material is shipped with this gas appliance. To place the ember material:

•Place dime-size pieces of Glowing Embers® just in front of the port trail, but not on or in between the ports See Figure 14.23. Embers are to be placed adjacent to burner port holes. Care should be taken so that the ports are not covered. Failure to follow this procedure will likely cause lighting and sooting problems.

•Embers CANNOT be placed directly over ports. Care should be taken not to cover the lighting trail of ports (from back to front).

NO EMBERS IN THIS AREA

Figure 14.23 Ember Placement

L. Install Outer Refractory Panels

1.Install glass assembly. Refer to Section 14.A for glass installation.

2.The refractory brackets are shipped wire-tied to the right side support opposite the valve. See Figure 14.24. Bend the back support of the refractory tab down. See Figure 14.25. Install the two refractory brackets to the glass frame and secure, but do not tighten. One screw per bracket is required. See Figure 14.26.

3.Install both outer refractory panels and install refrac- tory bracket to secure refractory panels in place. See Figure 14.26.

4.Install Outer Hearth. See Figure 14.27.

Figure 14.24 Shipping Location of Refractory Brackets

BACK SUPPORT

TAB

Figure 14.25 Back Support Tab Bent Into Position

Figure 14.26 Side Refractory Brackets

Figure 14.27 Outer Hearth Installation

Heat & Glo • ESC-42ST • 2146-900 Rev. o • 5/12 55