Heat & Glo LifeStyle ESC-42ST Remove the Shipping Materials, Clean the Appliance, Accessories

5.Ensure all three bottom glass latch tabs are engaged and centered in the three slots in the glass frame. The glass latch tab should protrude through the slot in the glass frame about 1/4 in. See Figure 14.5

Figure 14.5 Bottom Glass Latch Tabs Installed in Glass Frame

6.Engage the three glass latches on top. Push the top of the glass toward the fireplace. Use index fingers to manipulate top glass latches and pull out and latch the three glass assembly latches into the engagement grooves. See Figure 14.6 and Figure 14.7.

Figure 14.6 Top Glass Latch Access

GLASS FRAME

TAB

REFRACTORY

TAB

Figure 14.7. Top Glass Latch Detail

Removing Fixed Glass Assembly

•Remove glass assembly by reversing these glass in- stallation instructions.

B. Remove the Shipping Materials

Remove shipping materials from inside or underneath the firebox.

C. Clean the Appliance

Clean/vacuum any sawdust that may have accumulated inside the firebox or underneath in the control cavity.

D. Accessories

Install approved accessories per instructions included with accessories. Contact your dealer for a list of ap- proved accessories.

WARNING! Risk of Fire and Electric Shock! Use ONLY Hearth & Home Technologies-approved optional acces- sories with this appliance. Using non-listed accessories could result in a safety hazard and will void the warranty.

E. Installing the Optional Heat-Zone®Gas Kit

1.Remove the knockout from the side of the appliance and discard it (see Figure 14.8).

2.Center the duct collar around the exposed hole and attach it to the appliance with 3 screws. Note: Do this BEFORE final positioning of the appliance.

3.Determine the location for the air register/fan housing assembly.

Reference the Heat-Zone®Gas Kit instructions for the remaining installations steps.

HEAT-ZONE®

KNOCKOUTS

Figure 14.8 Heat-Zone® Gas Knockouts.

48 Heat & Glo • ESC-42ST • 2146-900 Rev. o • 5/12