Installation (for qualified installers only) | 15 |
Battery Pack / Learn Switch Installation
•The battery pack and learn switch must be mounted inside a junction box in a location that may be reached by the 12’ long battery box wires (see Figure 8).
Do not route the wires over the top
of the fireplace.
Battery Box and Learn Switch
(placed inside the junction box)
Junction Box (not supplied)
Staple the two wires near the junction box. This prevents the wires from slipping out of the junction box while the batteries are replaced. Take care to prevent damage to wires.
Remote Holder - used to cover the junction box. It is removed to replace batteries and access the learn switch
Battery Box Wire
Wire Length = 12'
Remove the Control Box to access the battery box wire. See the
illustration on the following page for wiring details.
Figure 8
© Travis Industries | 4090102 |