FireplaceXtrordinair 36CF installation manual Power Heat Duct Installation, Andiron Installation

Finalizing the Installation (for qualified installers only) 47

Power Heat Duct Installation

The optional power heat duct may be used with this fireplace. Refer to the part numbers below if you wish to insta this accessory. Instructions are includ with the power heat duct.

•Power Heat Duct (98500769)

•1080/36 ST-Pier CF Power Heat Duct Wiring Kit (94400995) - required for thermodisk controlled on/off operation

NOTE: The power heat duct must be attached at the time of firepla installation.

Andiron Installation

		Floor
Junction Box		Boot
		Maximum Duct
		Length = 20'
Rheostat
(with cover plate)
Use 10” x 3-1/4”		Blower
		Box
wall stack (duct)
when passing		Duct Adapter
through tight		(6” Round to 10” x 3-1/4”)
areas.		6" Duct
		Starter Ring
		Heat Duct
Grill		Electrical
	Wall Adapter	Wiring
	(for use on
	2 x 4 walls)
		Electrical
		Source

This fireplace includes four andiron brackets that allow for use of the optional andirons. Follow the directions below if installing andirons. NOTE: The firebacks should be installed prior to installing the andirons.

1The andiron clip attaches to the front of the burner (there are two on each side for a total of four). Remove the screw and attach the clip. NOTE: the firebacks are not pictured in the pictures.

2Secure the andiron to the clip with the bolts included with the andirons. We recommend you pre-thread the andirons to ease installation.

© Travis Industries 4090102 100-01212_000