FireplaceXtrordinair 36CF installation manual Rate Screws

46 Finalizing the Installation (for qualified installers only)

11The gas control valve has a propane conversion shaft that alters the outlet pressure. Remove the rubber cap over the propane conversion shaft and twist the small knob so the line points to “LP” (see Figure 27).

Inlet

Pilot Adj.

Pilot

Outlet

Main

NAT

LP

LP

NAT

Side View	Conversion Shaft
	(Note how it is in a lower
	position when switched to LP)

NATURAL TO PROPANE CONVERSION SHAFT (UNDER RUBBER CAP)

NG	LP
(Natural Gas)	(Propane)

Figure 27

12Remove the NG rate screw and replace it with the LP rate screw included in the owner’s pack (see Figure 28). Take care to not damage the rubber o-ring on the rate screw when installing.

Inlet

Pilot Adj.

Pilot

Outlet

Main

NAT

LP

PL

NAT

Rate Screws

RATE SCREW (BRASS)

NGLP

(Natural Gas) (Propane)

Figure 28

13Return the fireplace to the correct configuration (replace firebox and valve cover components).

14The fireplace receiver module will need to be configured for LP. This is done by pressing and holding the “Learn” switch FOR 20 SECONDS (see “Battery Pack / Learn Switch Installation” on page 15). The receiver will give off a short beep (less than 1 second) when configured for LP. The receiver will give off a long beep (3 seconds) when configured for NG. By pressing the switch for 20 seconds, you toggle between the two settings.

15Make the gas line connection, bleed the gas line (if applicable), start the heater and thoroughly leak-test all gas connections and the gas control valve (see Gas Line Requirements on page 18 for details). Check the pilot and adjust if necessary.

© Travis Industries 4090102 100-01212_000