FireplaceXtrordinair 36CF installation manual Remote Synchronization, Synchronizing the Remote

Installation (for qualified installers only) 17

Remote Synchronization

The fireplace is shipped with the remote and fireplace pre-synchronized. Do not synchronize the remote unless you are 100% sure it does not work correctly.

Synchronizing the Remote

NOTE: The fireplace must have power and the transmitter must have batteries to complete this process.

WARNING: Shut the gas off to the fireplace prior to conducting this process.

1Press the “Learn” button once. The fireplace will beep once.

2Press the “Mode” button on the remote. The fireplace will beep five times to indicate synchronization.

NOTE: Re-setting the Receiver Module

If the receiver module fails to synchronize with the remote after two attempts, you should re-set the receiver module. To do this, hold down the LEARN button for approximately 10 seconds until the receiver beeps 3 times. This indicates the receiver has been re-set and can be synchronized using the instructions above.

© Travis Industries 4090102 100-01212_000