Installation (for qualified installers only) | 21 |
Approved Vent Configurations
Exhaust Restrictor Adjustment
An exhaust restrictor is built into exhaust vent at the rear of the fireplace. It is used to adjust the flow rate of exhaust gases. Depending upon vent configuration, you may be required to adjust the restrictor. The charts for acceptable vent configurations detail the correct vent restrictor position. The restrictor is accessed from inside the firebox (remove the glass to gain access). To adjust the restrictor, remove the nut and bolt holding the restrictor in position, rotate the restrictor to the correct position, then replace the nut and bolt to secure (see Figure 11).
| Position # 2 |
| Position # 3 |
The fireplace ships in | Position # 4 |
restrictor position # 1. | Position # 5 |
| |
|
|
Figure 11
© Travis Industries | 4090102 |