GTO SL-2000B, SL-1000B installation manual See Illustration K, 18VAC

INSTALLATION OF THE GTO TRANSFORMER CONT.

STEP 12:	Illustration K
Strip 3/16” off the ends of the low voltage wire and	Correct			Wrong	Wrong
twist tightly. These wire ends will be attached to
the control board at the 18VAC terminals located
on the POWER IN terminal block (see Illustration
L).Wire sheathing should not come in contact with
terminals, however, it should not be stripped so far
that wires can come in contact with one another
(see Illustration K).	Wire	Terminal	Wire	Terminal	Wire	Terminal
		Block		Block		Block

Insert one transformer wire
into an	18VAC terminal.
Insert the other transformer
wire into the remaining
18VAC	terminal	( see		RED BLK ORG BLU GRN CLSEDG	OPNEDG	RE
illustration L). Transformer			18VAC SOLAR
wires can be connected to the			~ ~ – +
18VAC terminals regardless
of color.			POWER IN	FIRST OPERATOR		SECOND OPER

Tighten set	screws	against
exposed end of wires (see
Illustration	K). A	dab of	RED BLACK
household petroleum jelly
on each wire end will help
prevent corrosion.
The ACCESSORY terminal			Power Cable
block provides the connection
point for safety loops, wands,			from First Operator
push buttons, intercoms, card
readers, etc.	See	page 27	Low Voltage Wire
for more information about
connecting accessories.			from AC Transformer

Transformer

SURGE PROTECTOR

HINT: Keep a few mothballs in the control box to discourage insects from entering it and damaging the control board.

STEP 13:

Plug the transformer into the electrical outlet. Check to see if the green LED on the control board is on. If it is not, see the Troubleshooting Guide on page 30.

NOTE: Use of a surge protector is strongly recommended.

19