GTO SL-1000B, SL-2000B installation manual Control Board Settings, Right

CONTROL BOARD SETTINGS

DIP SWITCHES

The four DIP switches on the control board match the operator with the type of gate on which it is mounted. For example, gates may open right to left or left to right. Prior to packaging, the GTO/PRO SL-1000 and SL-2000 series control board was configured for a single slide gate that opens right to left. If your gate type matches this configuration, you DO NOT need to adjust the DIP switches. Proceed to the Potentiometers section on the next page. NOTE: The direction a gate opens is determined by standing inside the property and facing toward the gate.

NOTE: To change the DIP switch settings, you must turn the control box power switch OFF; move the switch; then turn the power back ON. Use a small screwdriver to

move the switches.

PULL/PUSH: Set to PULL for slide gates that open RIGHT to LEFT [factory setting]; PUSH for slide gates that open LEFT to

RIGHT.

SNGL/DUAL: Set to SNGL for a single gate leaf [factory setting]; DUAL for dual gate leaves.

SEQ1: Controls the opening order of dual gate leaves. See Setting the Control Board for Dual Gate Operator Installation on page 37

DIP switches

PULL/PUSH
		4
SNGL/DUAL		3
SEQ1	ON	2
SEQ2		1

OBSTRUCT
	SENS.
MIN	MAX
LEARN

for more information. (the factory setting is OFF).

SEQ2: Controls the opening order of dual gate leaves. See Setting

the Control Board for Dual Gate Operator Installation on page 37 for more information (the factory setting is OFF).

	AC		SOLAR
18V		~		–	+
~
POWER				IN

	TT	–
+	BA

RED BLK ORG BLU GRN CLS OPN

	TOR
FIRST	OPERA

						OSE
				AUTOCL
						60
		ATUS
PWR.	.	ST
	SW							120
					OFF
							A
					INERTI
					MIN			MAX
					OBSTRUCT
						SENS		.
					MIN			MAX
		PULL/PUSH
		AL
		SNGL/DU				LEARN
		SEQ1
		SEQ2
RED	BLK ORG BLU GRN EDGCLS EDGOPN	GRN ORG BLU	WHT	R	B	G
			ORY		RCVR
		ACCES	S
	TOR	ALARM
	OPERA
SECOND

20