IMPORTANT SAFETY INSTRUCTIONS
These warning labels should be found at the locations specified below. If any of them are missing, immediately contact your installer for replacements.
!WARNING
•Fingers, hands, and loose clothing may be dragged into chain sprockets.
•Fingers and hands can
be injured by rotating sprockets.
• Keep hands, fingers,
and loose clothing away from chain and chain opening in operator housing.
warning labels (3). Located on both sides and back of operator housing
SL
Series
Conforms to UL 325 STANDARDS
CUS Certified to
L | D | Maximum Gate: 500 lb. (226.7 kg); 30 ft. (9.1 m) |
| ISTE | |
9901178 | Voltage: 12 Vdc; Frequency: 0 Hz; Power: 93.2 W | |
Class I, II and III Vehicular Slide Gate Operator
Serial Number:
Disconnect operator ONLY when the gate is NOT moving.
TO MANUALLY OPEN AND CLOSE THE GATE:
1.Lift quick release pins UP, then pull them OUT of chain brackets.
2.Lay chain down and manually slide gate to desired position.
GTO, Inc. Tallahassee, Florida USA | RB2001 |
Series
Conforms to UL 325 STANDARDS
Certified to
CUS
LI | D | Maximum Gate: 1000 lb. (453.4 kg); 30 ft. (9.1 m) |
| STE | |
9901178 | Voltage: 12 Vdc; Frequency: 0 Hz; Power: 93.2 W | |
Class I, II and III Vehicular Slide Gate Operator
Serial Number:
Disconnect operator ONLY when the gate is NOT moving.
TO MANUALLY OPEN AND CLOSE THE GATE:
1.Lift quick release pins UP, then pull them OUT of chain brackets.
2.Lay chain down and manually slide gate to desired position.
GTO, Inc. Tallahassee, Florida USA | RB2002 |
!WARNING
•Moving parts inside are capable of causing injury to fingers and hands.
•DO NOT remove operator housing.
•Consult your safety manual before making adjustments.
•For service, call an experienced technician.
AUTOMATIC GATE OPENERS 1-800-543-GATE
warning label located on front of operator housing
!WARNING
• Fingers, hands, and loose clothing may be dragged into chain sprockets.
• Fingers and hands can be injured by rotating sprockets.
• Keep hands, fingers, and loose clothing away from chain and sprockets.
warning label located on top of control box
product identification and manual operation instruction label installed on control box cover
7