Brother BAS-311F-0, BAS-326F-0, BAS-311F-L instruction manual Adjusting the presser foot

9. STANDARD ADJUSTMENTS

(3) (4)

(5)

(8)

(7)

(6)

1249S

4.Fit the thread cutter connecting rod (6) on connecting lever pin (7), and install needle plate (5).

When fitting the connecting rod (6) on the connecting lever pin (7) and before tightening screws (3) and (4), move the needle plate back and forth a little bit to confirm that the movable knife (8) is pulled by the connecting rod (6).

(2)

Pin

(5)

(1)

1250S

5.When installing the feed plate (2), use a 2 mm- diameter pin (such as a needle) to align the hole in the needle plate (5) with the hole in the feed plate (2)

BAS-311F-0, -L “when the machine is at the

home position”, BAS-326F-0 “when the sewing machine has moved 20 mm (400 pulses) backward (in the Y direction) from the home position” and then tighten the screws (1).

9-7. Adjusting the presser foot

Turn the pulley by hand to lower the presser foot to the down position, and then proceed with the steps below.

		1. Loosen screw (1), set the bottom of the presser foot
		(2) lightly against the work piece, and then tighten
		screw (1).
		Note
		If the presser foot is lowered too far, the work piece
		will shift when sewing. Also, if the presser foot is too
(4)		high, skipped stitches may occur.
		2. Turn the pulley by hand, and make sure the needle
(3)		enters the center of the needle hole in the presser foot
		(2). If the needle is not aligned with the center of the
		needle hole, remove cap (3), loosen screw (4), and
(1)		turn the presser foot (presser bar) to adjust.
(2)
		If the needle projects past the presser foot when
	1251S	the presser foot is raised, injury may result.

46

BAS-311F-0, 311F-L, 326F-0