3.Slide hose clamp over end of hose. Slide suction hose onto hose barb (Figure 4).Tighten hose clamp securely using a standard 1/4” (6mm) screwdriver.
Figure 4 - Connect Suction Hose to Hose Barb
Attach Suction Hose to Strainer Basket
Slide hose clamp over hose. Attach open end of suction hose to strainer hose barb (Figure 5).Tighten hose clamp securely using a standard 1/4” (6mm) screwdriver.
Figure 5 - Attach Suction Hose to Strainer Hose Barb
ASSEMBLY
Connect Discharge Hose (Optional)
If desired, use a commercially available hose. DO NOT use a hose with an inside diameter smaller than the pump’s discharge port size.
1.Slide barb cuff over hose barb. Insert rubber seal into end of barb cuff (see Figure 2, earlier).
2.Screw hose barb assembly onto pump in clockwise rotation until hose barb assembly is tightened securely (Figure 6).
Figure 6 - Connect Hose Barb to Pump
3.Slide hose clamp over end of discharge hose. Slide discharge hose onto hose barb (Figure 7).Tighten hose clamp securely using a standard 1/4” (6mm) screwdriver.
Figure 7 - Connect Discharge Hose to Hose Barb
10