GE ZIR36N LH, ZIF36N RH Level, Or Freezer, Step Secure, To Sides, Connect, Water, Supply

Installation

36″ Refrigerators, Freezers

Step 5	All models have 4-point leveling. The front is supported
Level	by leveling legs, the rear is supported by wheels.
Refrigerator	•Adjust rear wheels beneath the product to just barely
or Freezer	touch the 2x4 block.
	•Turn the 7/16″ hex nut located above the front
	wheels. Turn to raise or lower the refrigerator.
	•For front leveling legs, use a 1-1/4″open-end
	wrench.
	•Adjust carefully, the refrigerator should be level and
	plumb with cabinetry, and align with toekick height.

Hex Nut Adjusts

Rear Wheels

Leveling Leg

CAUTION

The rear leveling wheels and front leveling

legs are limited to a maximum height adjustment of 1″. If the installation requires more than

84-1/2″height, the installer should elevate the refrigerator on a sheet of plywood or runners. Cabinetry trim could also be added across the top of the opening to shorten the opening. If you attempt to raise the refrigerator more than 1″, you will damage the front leveling legs and the rear leveling wheels.

PRUDENCE

Les roues de nivellement arrière et les pattes de nivellement avant permettent un réglage maximal de 25 mm (1 po). Si l’ouverture pour le réfrigérateur a une hauteur supérieure

à 2,15 m (84-1/2 po), l’installateur doit élever

le réfrigérateur sur une feuille de contre-plaqué ou des glissières. Il est également possible d’ajouter des baguettes de finition des placards sur le haut de l’ouverture afin de la réduire. Lever le réfrigérateur de plus de 25 mm (1 po) endommage les pattes de nivellement avant et les roues de nivellement arrière.

Step 6	NOTE: Whenever possible,
Secure	perform this step for
Refrigerator	additional anti-tip security.
or Freezer	This step can be used as an
to Sides	alternate to Step 4, Anti-Tip
	bracket installation, whenever
	brackets cannot be used.

Stud

OR

Refrigerator

Cabinet

Door

Spacer

Block

	When using 1/2″ to 3/4″ side panels, the front flange	• Follow the same procedure on the opposite side.
	of the case trim is attached to the side panel.	If the product is installed between cabinets with no
	• Open door to access case trim.
		side panels or in a custom enclosure, install a spacer
	• Drill hole in trim slightly below the interior opening.
		block as shown.
	Drive screw through the trim and into the side
	panel.
Step 7	•Locate and bring tubing to the front of the cabinet.
Connect	•Turn the water on to flush debris from line. Run
Freezer	about a quart of water through tubing into a
Water	bucket, then shut-off water.
Supply	Copper Tubing:
	• Slip a 1/4″ nut and ferrule (provided) over both ends
	of the copper tubing. Insert tube into the union
	fitting on the unit and tighten nut to union.
	• Turn on the water to check for leaks.
	GE SmartConnect™ Tubing:	NOTE: Make sure excess tubing length does not
	• Insert the molded end of the tubing into the
		interfere with toekick installation.
	refrigerator connection. Tighten the compression
	nut until it is just hand tight.
	• Tighten one additional turn with a wrench.
	Overtightening can cause leaks!
16	• Turn on the water to check for leaks.