GE ZIR36N RH ZKHTR1 Trim Kit For 3/4″ Panels, Tools and materials required, Part List, Before

ZKHTR1 Trim Kit (For 3/4″ Panels)

Support for Custom Handles

Kit Contents	Right hand door swing models are illustrated in these
	instructions. Follow these instructions for left hand
	models.

Tools and materials required:

•#2 Phillips screwdriver

•Drill and appropriate bits

•Custom door panel

•Custom handle

•Safety glasses

NOTE: This kit must be used in combination with

ZKTR36LH or ZKTR36RH trim kit for 3/4″ panel trim.

Part List:

A. Handle extrusion (for left hand models)

B. Handle extrusion (for right hand models)

This kit provides the necessary framework to install a custom handle, of your choice, onto a 3/4″ thick decorator door panel. (Handles not included.) The handle extrusion allows the custom handle to be secured to the door structure, rather than the door panel.

•Select handle extrusion for your model, discard other extrusion.

Before	3/4″ custom door panel must be routed to			Custom Panel
you begin	accommodate these door handle extrusions. Rout			1-13/16"
	the panel as illustrated, 1/4″ deep, and 1-13/16″wide
		1/4" Max.		Back Side
	on the handle side.
	Refer to installation instructions for ZKTR36LH or		Handle Side
	ZKTR36RH trim kit for 3/4″ custom panels:
	• Follow Step 1 to remove the standard	IMPORTANT: Optimal final appearance depends on
	aluminum trim.	careful routing depth. Do not exceed 1/4″ routing depth.

•Follow Steps 2 and 3 to attach new 3/4″ trim pieces and to install panel support brackets.

26