GE ZIF36N LH, ZIR36N LH Temporarily mount door panel, Locate, Position, Assemble, Extrusion

ZKHTR1 Trim Kit (For 3/4″ Panels)

Support for Custom Handles

Step 1 Temporarily mount door panel

• Place the prepared 3/4″ custom door panel on the bottom trim with support bracket tabs inserted into trim slots.

• Push the panel back against the steel door, making sure the panel is flush with the hinge side trim.

• Secure the panel to the trim temporarily by

	driving 2 screws through the backside of the
	trim at the top.
	• Slide the handle extrusion in between the panel
	and steel door.
	• Temporarily secure the extrusion to the door with
	2 screws.
Step 2
	• Determine the location of the custom
Locate	handles and carefully mark centerlines
position	of the screw holes. The handles must be
of handle	located 3/4″ to 1-1/2″from the edge of
	the extrusion.
	• Drill 1/16″ pilot hole through the panel until
	it starts into the aluminum extrusion. This
	will mark the matching location for drilling
	a clearance hole when assembling the
	extrusion, panel and handle.	3/4" Min.
		1-1/2" Max.

Step 3	• Remove the handle extrusion, the 2 temporary
Assemble	screws and custom panel.
panel,	• Drill 1/16″ pilot hole through extrusion.	Screw
extrusion	• Drill clearance holes through the panel and
and handle	extrusion.
	• Assemble the panel, extrusion and custom handle.
	• Install screw(s) long enough to pass through the
	extrusion, door panel and into the handle.

3/4" Min.

1-1/2" Max.

27