GE ZIR36N LH When Installed into a corner, Side By Side Installation Freezer Refrigerator

DESIGN INFORMATION

Design Information

36″ Refrigerators, Freezers

Clearances

130° Door

Swing

130°

25" Min. to Wall

90° Door Swing

36-3/4"

4" Min. to Wall

2"

15"

Clearances for two products installed side-by-side with the same (left or right) door swing

Allow 2″ minimum clearance between the products to

Factory set for a 130° door swing. Order WX14X99 adjustable door stop to reduce swing to as little as 90°.

When Installed into a corner:

Allow 25″ for a full 130° door swing. Allow 15″ for pan removal. Allow 4″ min. clearance when door swing is adjusted to a 90° opening for pan access, but pan removal is restricted.

25"		0"		25"
Min. to	130° Door		130° Door	Min. to
Wall				Wall
	Swing		Swing

Clearances for Multiple Single Door Installations In a side-by-side installation of a left and right door swing product, no clearance between the units is required. If you are installing 3/4″ thick custom panels, order ZUG75 Unified Grille Panel Kit for one continuous grille panel.

prevent door swing interference. Order the WX14X99 adjustable door stop to reduce the factory set 130° door swing. Allow 15″ minimum to a wall to achieve full drawer extension and pan removal. Additional clearances are required when using custom handles and panels.

NOTE: ZUG75 Grille Panel Kit will not fit this

installation.5"

Clearances for two products installed side-by-side with right and left side hinges together

Allow 5″ minimum between the two products to prevent one door from striking the other. Use the WX14X99 adjustable door stop to reduce the factory set 130° door swing and to allow pan removal. Additional clearances are required when using custom handles and panels.

NOTE: ZUG75 Grille Panel Kit will not fit this installation.

Side By Side

Installation

Of Freezer

And Refrigerator

For a complete food storage center, install a Monogram Freezer and Refrigerator side by side. Order ZUG75 Unified Grille Panel Kit for one continuous 3/4″ panel.

• Electrical and water locations must
be located as shown for either type	84-1/2" max
of installation. A separate 115V,
	83-1/2" min
60Hz. 20 amp power supply is
	Finished
recommended for each product.
	Opening

NOTE: Additional cutout width may be required when side panels are used. Add side panel thickness to the finished cutout to calculate rough-in width. See installation examples below.

	*Finished Width
2-1/2"	Electrical	Wall View
		28-1/2"
6"		6"
5"		5"
24-3/4" Total		75" From Floor
Depth		to Bottom
3-1/2" Water Supply 3-1/2"		of Electrical
		Area
5"	5"

10" 3-1/2" 10"

FreezerRefrigerator

*72″ min. for a flush installation 71-1/2″min. for a semi-flush installation

Installation Examples

4

Side panels are required whenever the sides of the	Therefore, the rough-in dimensions must allow
product will be exposed.	for side panel thickness. In a flush and semi-flush
1/2″ to 3/4″ side panels are normally set into place	installation, the finished dimension (width of the
and fastened to adjacent cabinetry or back wall	opening after side panels are installed) must
	accommodate the full width of the product.
before rolling the refrigerator or freezer into the
	See page 11 for side panel sizes.
opening.