Amana ARS9167AB Install Water Filtration Cartridge Some models, Connecting Water Supply

Page 4
2.Install Water Filtration Cartridge (Some models)

!CAUTION

To avoid property damage, protect soft vinyl or other flooring with cardboard, rugs, or other protective material when moving refrigerator.

f.Rehang doors by reversing steps a–e. Use a dime at top of doors to space doors ¾" (18 mm) from cabinet.

2.Install Water Filtration Cartridge (Some models)

a.Remove bypass cartridge from water filter head in rear right corner of refrigerator section. Twist cartridge counterclockwise ¼ turn and pull down to remove. Save bypass to use if water filter replacement cartridge is not immediately available.

b.See Water Filtration System Installation and Operating Instructions provided with water filter cartridge for filter installation and operation.

The amount and condition of water used determines the life span of the water filter cartridge. Replacement for a household with average water consumption would be approximately six months. If water usage is high, or if water is of poor quality, replacement may have to take place before six months. See Water Filtration System Installation and Operating Instructions provided with water filter cartridge for more information.

3. Connecting Water Supply

!WARNING

To avoid electrical shock which can cause severe personal injury or death, disconnect power to refrigerator before connecting water supply. After connecting water supply, connect power.

!CAUTION

To avoid property damage, observe the following:

•Confirm water pressure to water valve is between 20 and 100 pounds per square inch.

•If water filter will be installed, water pressure to water valve must be a minimum of 35 pounds per square inch.

•Tighten nut by hand to avoid cross threading. Finish tightening nuts with pliers and wrenches. Do not overtighten.

•Check for water leaks and correct if necessary before returning refrigerator to normal location and 24 hours after connecting.

Important

•Before connecting water supply, contact a plumber to connect copper tubing to household plumbing in compliance with local codes and ordinances.

•A self–piercing or 3/16" (4.8 mm) saddle valve is not recommended. Both reduce water flow, become clogged with time and may cause leaks if

repair is attempted. The correct type of shut off valve requires a ¼" (6 mm) hole to be drilled in water supply pipe prior to valve attachment. The manufacturer is not responsible for property damage caused by improper water connection.

Materials Required

¼" (6 mm) flexible copper tubing. Length of copper tubing must reach from water supply connection plus an additional 8' (2 m) for service loop behind refrigerator.

Procedure

a.Remove plastic cap from water valve inlet port. Place brass nut and brass sleeve on copper tubing. Insert copper tubing into water valve inlet port. Connect brass nut on copper tubing to water valve inlet port. Confirm copper tubing is secure by pulling on copper tubing.

A

C

B

D

E

A.

“P” clamp

B.

Copper tubing

C.

Brass nut

D.

Brass sleeve

E.Water valve inlet connection

b.Turn on water supply to refrigerator and check for leaks. Correct any leaks.

c. Create service loop using extreme care to avoid kinks. Secure copper tubing to refrigerator

cabinet with a “P” clamp.

4.Plug in power cord.

5.Move refrigerator into final location.

!CAUTION

To avoid property damage, protect soft vinyl or other flooring with cardboard, rugs, or other protective material when moving refrigerator.

a.Slide appliance cart under side of refrigerator. Wrap refrigerator with blanket or pad. Thread cart strap around refrigerator and tighten. Do not overtighten

strap. Move refrigerator in front of final location.

!CAUTION

To avoid damage or breakage to adjusting bolt, do not use power tools to correct leveling.

6. Stabilize refrigerator and align doors.

If refrigerator rocks or is not stable on floor perform the following:

• Determine which rear corner is rocking.

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Keep these instructions for future reference. Be sure this Side-by-Side Refrigerator Owner’s Manualmanual stays with refrigerator Contents ServiceAsure Extended Service Plan Parts and AccessoriesInstallation Instructions DANGERProper Disposal of your Refrigerator For more information visit our web site2. Install Water Filtration Cartridge Some models 3. Connecting Water Supply4. Plug in power cord 5. Move refrigerator into final location ProcedureControls Setting ControlsRefrigerator and Freezer Controls Installation Checklist Consumer Installer DoorsLeveling Ice MakerRefrigerator Features Refrigerator ShelvesChiller Fresh System Some models Deli Drawer Some modelsStorage Rack Some models Covered Storage Bucket Some modelsDairy Center Some models Snack Shelf Some modelsTemperature-Controlled Beverage Chiller Some models Door Buckets and ShelvesFreezer Features Adjustable Divider Some modelsAutomatic Ice Maker Dispensing models Tall Package Retainer Some modelsTilt-Out Bin some models Removing Ice BucketIce ’N Water Slide Control Dispenser Some models Water Dispenser OperationIce Dispenser Operation Taste and OdorIce ’N Water Electronic Control Dispenser Some models Dispenser LightDispenser Lock Automatic Lock OutCare and Cleaning GeneralOdor Removal AdhesivesGlass Shelves Light BulbsLower refrigerator section Some models Freezer sectionNormal Operating Sounds Before Calling For Service Energy Tips Vacation TipsPage ADVERTENCIA ContenidoRequerimientos eléctricos Identificación del modeloPELIGRO Forma apropiada de desechar el refrigeradorInstrucciones para la instalación 1. Quite las puertas si es necesarioPRECAUCIÓN 2. Instalación del cartucho de filtración de agua en algunos modelos3. Conexión del suministro de agua d. Modelos sin surtidor5. Mueva el refrigerador a la ubicación final 4. Conecte el cordón eléctrico6. Estabilice el refrigerador y alinee las puertas Controles del refrigerador y del congelador ControlesControles de ajuste Lista de verificación de la instalación Consumidor Instalador PuertasNivelación Máquina para hacer hieloCaracterísticas del refrigerador Repisas del refrigeradorSistema Chiller Fresh en algunos modelos Cajón para embutidos Deli Drawer en algunos modelosCajones para verduras Garden Fresh en algunos modelos Parrilla para almacenamiento en algunos modelosRecipiente cubierto para almacenamiento en algunos modelos A. Cajón para frutas y verdurasCentral para productos lácteos en algunos modelos Repisa para bocadillos en algunos modelosSeparador ajustable en algunos modelos Repisas y compartimientos de la puertaDispositivo de retención para paquetes altos en algunos modelos IMPORTANTECaracteristicas del congelator Máquina automática de hielos en los modelos con surtidorSistema Stor-Mor Cubo inclinado en algunos modelosFuncionamiento del surtidor de agua Funcionamiento del surtidor del hieloSabor y olor Luz del surtidor en algunos modelosFoco del surtidor Cierre del surtidorCandado automático Luz del filtroCuidado y limpieza GeneralidadesLimpieza del acero inoxidable Eliminación de oloresSerpentín del condensador Repisas de vidrioFocos Sección superior del refrigeradorSonidos normales de funcionamiento Surtidor de hielo y agua Ice ‘N’Water en algunos modelos2. Ventilador del congelador - el aire se acelera y zumba 4. Calentador de descarchado hace chirridos, silba o crujeAntes de llamar para solicitar servicio Sugerencias para conservar energía Sugerencias para cuando sale de vacacionesLa garantía corresponde a los números de modelo que tengan ARS o DRS como los primeros tres caracteres del número de modelo, y que contengan los números 7, 8 ó 9 en la séptima posición por ejemplo, ARSxxx7xx Service après-vente Ce symbole indique une mesure de sécuritéMISE EN GARDE Table des matièresPièces et accessoires Instructions d’installationMise au rebut du réfrigérateur 1. Enlever les portes si nécessaire2. Installation de la cartouche de filtration d’eau certains modèles 3. Raccordement de l’alimentation en eau4. Brancher le cordon d’alimentation 5. Déplacer le réfrigérateur à l’endroit desiréCommandes 6. Stabilisation du réfrigérateur et aligne- ment des portesSi le dessus des portes n’est pas de niveau, procéder comme suit Retirer la grilleListe de contrôle d’installation Propriétaire Installateur PortesMise à niveau Appareil à glaçonsCaractéristiques du réfrigérateur Clayettes du réfrigérateurSystème Chiller FreshTM sur certains modèles Tiroir Deli DrawerTM certains modèlesBacs à légumes à humidité contrôlée Garden FreshTM certains modèles Rayon de rangement certains modèlesCompartiment de rangement couvert certains modèles Casier laitier certains modèlesRefroidisseur de casse-croûte certains modèles Compartiments de porte et clayettes Séparateur réglable certains modèlesConteneur de grands emballages certains modèles Caractéristiques du congélateur Appareil à glaçons automatique modèles avec distributeurSystème Stor-Mor Retrait du bac à glaceDistributeur à curseur Ice ‘N’ WaterTM certains modèles Fonctionnement du distributeur d’eauFonctionnement du distributeur de glaçons Goût et odeurDistributeur à commande électronique Ice ‘N’ Water certains modèles Lumière du distributeurVerrouillage du distributeur Verrouillage automatiqueEntretien et nettoyage Lumière du filtreGénéral Suppression des odeursAdhésifs Joints de porteBobine de condensateur Clayettes en verreCompartiment congélateur Bruits de fonctionnement normauxDistributeur Ice ‘N’ WaterTM certains modèles Avant d’appeler le technicien Conseils pour les vacances Conseils pour économiser l’énergieLe débit d’eau est moins fort qu’à l’habitude En aucun cas Amana n’est responsable des dommages indi
Top Page Image Contents