Aiwa Z-R555 manual Insert the tape to be recorded on into Deck, Press on Deck 1 to start recording

IISET

l–

Preparation

● Use Type I (normal) tapes only.

● Set the tape to the point where recording will start.

● Note that recording is done on only one side of the tape.

1 Insert the tape to be recorded on into Deck 1.

Insert the tape with the side to be recorded on first facing out

from the unit.

i	v	I I	I	I	I	!	I
h,~J

2 Press one of the function buttons and prepare the source to be recorded.

To record from a CD, press CD and load the disc(s).

To record from a tape, press TAPE. Then, insert the original tape into Deck 2 and play it.

To record from a radio broadcast, press TUNER/BAND and tune in to a station.

To record from a connected source, press VIDEO/AUX/

PHONO and play.

3 Press ● on Deck 1 to start recording.

-is depressed simultaneously.

When the selected function is CD, playback and recording start simultaneously.

la

To stop recording, press WA on Deck 1.

To pause recording, press [1 on Deck 1.

To resume recording, press it again.

To record selected tracks of the CD

Before pressing ● , program the tracks (see page 10).

To record part of the CD

When ● is pressed, recording always starts from the first track.

To start in the middle of a track, play the CD first and press 11SET

for CD at the point you wish to start recording from. Then, press

●. The pause mode for CD button is released automatically and recording stark.

Sound adjustment during recording

The output volume and tone of the speakers or headphones may be freely varied without affecting the recording.

●Do not press the buttons on Deck 2 during recording.

“● cannot be depressed if the erasure prevention tab on the side of the tape to be recorded is broken off.

●If squealing or beating sounds occur when recording an FM broadcast, press MONO TUNER while pressing SHIFT on the remote control, so as to eliminate the noise.

Each time these buttons are pressed, “MONO is turned on and off on the display.

To erase a recording

A previous recording is erased when a new recording is made on that part of that tape.

1 Insert the tape you want to erase into Deck 1.

2Press TAPE and stop all the tape operation in Deck 2.

3Windup the tape to the point where the erasure is to be started.

4Press ● on Deck 1 to start the erasure.

About cassette tapes

●To prevent accidental erasure, break off the plastic tabs

on the cassette tape after recording with a screwdriver or other pointed tool.

Side A Tab for side A

To record on the tape again, cover the tab openings with adhesive tape, etc.

●120-minute or longer tapes are extremely thin and easily deformed or damaged. They are not recommended.

●Take up any slack in the tape with a pencil or similar tool before use. Slack tape may break or jam in the mechanism.

11 ENGLLSH