Aiwa Z-R555 manual To turn the unit on, Press CLOCtVDIMMER once, then press Enter within 4 seconds

CD

DEMO

b

To turn the unit on

Press one of the function buttons (TAPE, TUNER/BAND, VIDEO/ AUWPHONO, CD). Playback of the inserted disc begins, or the previously tuned station is received (Direct Play Function).

POWER is also available.

When the unit is turned on, the disc compartment may open and close to reset the unit.

To turn the power off

Press POWER.

Flash window

The window on the top of the unit lights up or flashes while the unit’s power is on.

To turn off the light of the top window, press ■ while pressing CD. To turn back on, repeat the above.

Game Demo

When the AC cord is connected, the display window demonstrates the game Demo. When the power is turned on, the game Demo is overridden by the operation display. When the power is turned off, the game Demo is restored.

To cancel the game Demo

Press DEMO. To re-activate the game Demo, press DEMO again.

To play the game Demo

1Press DEMO so that the game Demo displays.

2Press -.

Three numbers on the display start to run.

3Press ■ once.

The number on the left side stops.

4Press 9 twice to stop the remaining two numbers.

Scoring:

20 points are given to start the game.

If all the numbers are eaual, 50 points are added to the score. If not eaual, one point is subtracted.

If the gained points reach 9999, you win. If the gained points fall to O, you lose.

To reset the game Demo

Press DEMO twice, then press -. The game starts again.

m

●During playing the game Demo, ■ and E are available only for the same Demo. Cancel the ciame Demo to use these buttons ;or other functions such as-CD playing, etc.

●During the game Demo, some indicators unrelated with the actual operation light up on the display.

I ib---- 1 —til !

1 Press CLOCtVDIMMER once, then press ENTER within 4 seconds.

When using the remote control

Press CLOCK whiIe pressing SHIFT, then press llSETwitbiD

4 seconds.

2 Turn MULTI JOG to designate the hour, then press

ENTER.

The hour stops flashing and the minute starts flashing.

3 Turn MULTI JOG to designate the minute, then press ENTER.

The minute stops flashing on the display and the clock starts from 00 seconds.

To display the current time

Press CLOCWDIMMER once. The time is displayed for 4 seconds.

However, the time cannot be displayed during recording.

To switch to the 24-hour standard

Press CLOCK/DIMMER once and then press ■ within 4 seconds.

Repeat the same procedure to restore the 12-hour standard.

If the clock display flashes

This is caused by a power interruption. The current time needs to be reset.

If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be reset.

*44 and W are also available instead of MULTI JOG.

*IISET is also available instead of ENTER.

5 ENGLISH