Aiwa Z-R555 manual To demagnetize the heads, Sound is emitted from one speaker only

Page 18

Occasional care and maintenance of the unit and the software are needed to optimize the performance of your unit.

To clean the cabinet Use a soft and dry cloth.

If the surfaces are extremely dirty, use a soft cloth lightly moistened with mild detergent solution. Do not use strong solvents, such as alcohol, benzine or thinner as these could damage the finish of the unit.

To clean the heads and tape paths

After every 10 hours of use, clean the heads and tape paths with a head cleaning cassette or cotton swab moistened with cleaning fluid or denatured alcohol. (These cleaning kits are commercially available.)

When cleaning with a cotton swab, wipe the recording/playback head, erasure head (Deck 1 only), capstans, and pinchrollers.

Recording/

Erasu

stan

After cleaning the heads and tape paths with a liquid head cleaning cassette or a moistened swab, wait until the cleaned parts are completely dry before inserting the tapes.

To demagnetize the heads

The heads may become magnetized after long-term use. This may narrow the output range of recorded tapes and increase noise. After 20 to 30 hours use, demagnetize the heads with any commercially available demagnetizer.

Care of discs

●When a disc becomes dirty, wi~e the disc from the center out

●After playing a disc, store the disc in its case. Do not leave the disc in places that are hot or humid.

Care of tapes

●Store tapes in their cases after use.

●Do not leave tapes near magnets, motors, television sets, or any source of magnetism. This will downgrade the sound quality and cause noise.

●Do not expose tapes to direct sunlight, or leave them in a car parked in direct sunlight.

~7 ENGLISH

If the unit fails to perform as described in these Operating Instructions, check the following guide.

GENERAL

There is no sound.

●Is the AC cord connected properly?

●Is there a bad connection? (+ page 3)

●There may be a short circuit in th; speaker terminals.

+Disconnect the AC cord, then correct the speaker connections.

●Was an incorrect function button pressed?

Sound is emitted from one speaker only.

. Is the other speaker disconnected?

An erroneous display or a malfunction occurs.

+Reset the unit as stated below.

TUNER SECTION

There is constant, wave-like static.

●Is the antenna connected properly? (+ page 3)

●Is the signal weak?

+ Connect an outdoor antenna.

The reception contains noise interferences or the sound is distorted.

●Is the system picking up external noise or multipath distortion?

+Change the orientation of the antenna.

+Move the unit away from other electrical appliances.

CASSETTE DECK SECTION

The tape does not run.

●Is the deck in pause mode? (+ page 8)

The sound is off-balance or not adequately high.

●Is the playback head dirty? (+ page 17)

Recording is not possible.

●Is the erasure prevention tab on the tape broken off? (+ page 11)

●Is the recording head dirty? (+ page 17)

Erasure is not possible.

●Is the erasure head dirfy? (+ page 17)

● IS a metal tape being used?

-

High frequency sound is not emitted.

●Is the recording/playback head dirty? (+ page 17)

CD PLAYER SECTION

The CD player does not play.

●Is the disc correctly placed? (+ page 9)

●Is the disc dirty? (+ page 17)

●Is the lens affected by condensation?

+ Wait approximately one hour and try again,

To reset

If an unusual condition occurs in the display window or the cassette decks, reset the unit as follows.

1Press POWER to turn off the power.

2Press POWER to turn the power back on while pressing ■ CLEAR. Everything stored in memory after purchase is canceled.

If the power cannot be turned off in step 1 because of a malfunction, reset by disconnecting the AC cord, and connect it again. Then carry out step 2.

Page 17 Page 19
Image 18
Page 17 Page 19
Contents IlE3iE Installation Carts and stands When placed orElectric Power AC power cordDamaae Requiring Service Connect the stereo turntable to the main unit Check the AC voltageConnect the right and left speakers to the main unit Connect the supplied antennasAM antenna Turn Multi JOG to designate the hour, then press To turn the unit onPress CLOCtVDIMMER once, then press Enter within 4 seconds Turn Multi JOG to designate the minute, then press EnterSound adjustment during recording To select with the remote controlPress GEQ repeatedly to select the equalization mode Press T-BASSTo change the AM tuning interval To select a band with the remote controlWhen an FM stereo broadcast contains noise Press TUNER/BAND to select the FM or AM bandTo play one disc onl~ press one of Disc Direct Play To start play when the power is off Direct Play FunctionSelecting a track with the remote control To stop play, pressRepeat steps 1 Selecting a preset number on the main unitTo clear a preset station II ~Press Prgm while pressing Shift in stop mode Press one of Disc Direct Play 1-5 to select a discInsert the tape to be recorded on into Deck Press on Deck 1 to start recordingTo erase a recording Press Numbered Buttons Remote Insert the tape into DeckPress on Deck 1 to start recording on the first side To designate TapeTo check the order of the programmed track numbers Repeat for the rest of the tracks for side aDirect Play 2, then press +10 and O To change the program of each sidePress Timer to display ~, then press Enter within 6 seconds Get ready for the Tape function or the timer recordingPrepare the source Adjust the volume to minimum Adjust the volume according to your preferencePress VIDEO/AUX/PHONO on the main unit Press VIDEO/AUX/PHONO UsedTo demagnetize the heads Sound is emitted from one speaker onlyCassette deck section Entrada de objetos y l~quidos Tenga cuidado de que ELECTRiCAS, no Quite LA CubiertaSuperficie de montaje Ponga la unidad sobre una Eneraia electricaSintonizacion Manual Preajuste DE Emisoras No Trate DE Reparar LA Unidad Usted MismoAjustes DE Audio Ecualizador Grafico BasicasImportante Conecte Ias antenas suministradasConecte el cable de alimentacion de CA a una toma de CA Speakers LConexion DE UNA Antena Exterior EspanolGire Multi JOG para designar la hors, y Iuego pulse Enter Gire Multi JOG para designar el minute, y Iuego Pulse EnterDemo Pulse T-BASS Para reducir la iluminacion del visualizadorGEQ Shift Phones Para cambiar el intervalo de sintonizacion de AM Pulse Tunefuband para seleccionar la banda de FM ode AMPara buscar rapidamente una emisora busqueda automatic Rece Mono Tuner Band ShiftAjuste DEL Temporizador Para Dormir Plato Giradiscos Cable DE Bajada LA Antena Unidad DE DescargaCompruebe la tension de CA Conecte el plato giradiscos estereo a la unidad principalPara posicionar Ias antenas Antena de FM Insertion de Ias pilasCuando reemplazar Ias pilas Para desconectar la alimentacion Para cancelar la demostracion del juegoPara encender la unidad Ventanilla parpadeanteUtilization de auriculares Pulse repetidamente GEQ mientras pulsa Shift@ Modo de sintonizacion de emisoras preajustadas El Cintas utilizable Repita Ios pasos 1 yPara borrar una emisora preajustada Pulse TAPE, Iuego pulse WA para abrir el portacaseteEditi Check Random Repeat Shift DiscNGE II IL El Ios discos Inserte la cinta que vaya a grabar en la platinaPulse de la platina 1 para iniciar la grabacion Antes de pulsar , programe Ios temas consulte la paginaInserte la cinta en la platina EditPara detener la grabacion Prepare la fuente de sonido Vaya a reproducer en primer Iugar en el compartimientoPor temporizador se visualizaran durante 4 segundos Pulse VIDEO/AUX/PHONO de la unidad principal Ajuste el volumen segun sus preferenciasPulse Sleep mientras pulsa Shift Preparatives Inicie la reproduction en el plato giradiscosPulse VIDEO/AUX/PHONO Cuando no se utilice la toma CD Digital OUT OpticalCD Digital OUT Optical Para desmagnetizar Ias cabezas La cinta no se mueveSeccion del Et indiquee sur I’appareil Explication des symboles graphiquesAlerter I’utilisateur sur la presence d’une SX-ZR25Re~arations exiaeant I’intervention d’un rxofessionnel Nettoyez I’appareil comme indique clans Ie mode d’emploiAntenne exterieure NE PAS Essayer DE Reparer SOI-MEME L’APPAREILRaccordez Ie tourne-disque stereo a I’appareil principal Verifiez la tension du secteurEnceintes Raccordez Ies antennes fournies’ACCORDEMENT ‘D’UNE Antenne Exterieure Mode de demonstration de jeu Pour jouer Ie jeu de demonstrationPour reinitialiser Ie jeu Appuyez sur T-BASS Pour annuler Ie mode selectionneShift Bass Volume Utilisation d’un casqueAppuyez sur Tunewband pour selectionner la gamme FM ou AM Mono Tuner Band ShiftRepetez Ies etapes 1 et Appuyez sur Tape puis sur W= pour ouvrir Ie porte-cassetteAppuyez sur pour commencer la lecture Direct PI-AYChargez Ies disques PRGapparalt sur I’afficheur Selectionnee Selectionnees Numero de programmePlages selectionnees Inserez la cassette a enregistrer clans la platine ’enregistrementLa premiere Face De la telecommande Tout MaintenantAppuyez sur La platine Pour cornmencer Appuyez Sur10~~d-’ Face B de la cassette face arrierePreparez la source ‘~#Enter Reglez Ie volume au minimum Reglez Ie volume selon vos preferencesLancez la lecture du disque sur Ie tourne-disque CD Digital OUT Appuyez sur VIDEO/AUX/PHONOMettez I’appareil raccorde en marche OpticalSection Platine a Cassette GeneralitiesSection Tuner Section Lecteur CDIHF Droits D’AUTEURName/Nombre/Nom Page/Pagina/Page ~OpENiCLosE@ Deck Name/Nombre/Nom Page/Pagina/Page

Z-R555 specifications

The Aiwa Z-R555 is a classic piece of audio equipment that exemplifies the best in compact sound technology from its era. Designed with portability and ease of use in mind, this model quickly became a favorite among music enthusiasts who sought a reliable, high-quality playback device.

One of the standout features of the Aiwa Z-R555 is its dual cassette deck, which allows users to play and record from various sources. This feature makes it ideal for creating mixtapes or copying favorite tracks from one cassette to another. The ability to play both normal and high-quality cassettes provides flexibility for audiophiles who appreciate different sound formats.

Equipped with an AM/FM radio tuner, the Z-R555 enables users to enjoy a wide range of broadcasting options, enhancing its versatility as a standalone audio system. The tuner is engineered with digital frequency synthesis, which results in accurate tuning while minimizing interference, ensuring crystal-clear radio reception.

The Z-R555 also boasts a robust amplifier that delivers impressive sound quality with minimal distortion. This solid amplification allows it to drive a range of speaker types, making it suitable for various listening environments, from small rooms to larger spaces. The speaker output is complemented by a range of EQ settings, allowing users to fine-tune their listening experience to match their musical preferences.

In terms of design, the Aiwa Z-R555 features a user-friendly interface with an easy-to-read LED display that shows track information and radio frequencies. The layout of buttons is intuitive, enabling quick access to playback, recording, and tuning functions. This focus on user experience reflects Aiwa's commitment to creating consumer-friendly products.

Portability is another hallmark of the Z-R555. Its compact design ensures that it is easy to transport, making it ideal for users who wish to enjoy their music on the go. Additionally, the device supports battery operation, adding to its versatility, especially for outdoor gatherings or travel.

In conclusion, the Aiwa Z-R555 represents a blend of innovative technologies and practical features that have garnered a loyal following. With its dual cassette decks, AM/FM tuner, dynamic sound quality, and user-friendly design, this model is a testament to Aiwa's legacy in audio excellence, appealing to both casual listeners and serious audiophiles alike.
Top Page Image Contents