OPERATING INSTRUCTIONS
FELLING
Felling is the term for cutting down a tree. Small trees up to
WARNING: A retreat path (A) should be planned
and cleared as necessary before cuts are started. The retreat path should extend back and diagonally to the rear of the expected line of fall, as illustrated in Fig. 8.
CAUTION: If felling a tree on sloping ground, the
chain saw operator should keep on the uphill side of the terrain, as the tree is likely to roll or slide downhill after it is felled.
NOTE: Direction of fall (B) is controlled by the notching cut. Before any cuts are made, consider the location of larger branches and natural lean of the tree to determine the way the tree will fall.
B
A
Fig. 8
WARNING: Never walk in front of a tree that has been
notched.
Make the felling cut (D) from the other side of the tree and 1.5 - 2.0 inches
Fig. 9
Never saw completely through the trunk. Always leave a hinge. The hinge guides the tree. If the trunk is completely cut through, control over the felling direction is lost.
WARNING: Before making the final cut, always recheck
the area for bystanders, animals or obstacles.
Insert a wedge or felling lever in the cut well before the tree becomes unstable and starts to move. This will prevent the guidebar from binding in the felling cut if you have misjudged the falling direction. Make sure no bystanders have entered the range of the falling tree before you push it over.
Felling Cut:
1.Use wooden or plastic wedges (G) to prevent binding the bar or chain (H) in the cut. Wedges also control felling (Fig. 10).
2.When diameter of wood being cut is greater than the bar length, make 2 cuts as shown (Fig. 11).
WARNING: Do not cut down a tree during high or
changing winds or if there is a danger to property. Consult a tree professional.Do not cut down a tree if there is a danger of striking utility wires; notify the utility company before making any cuts.
Normally felling consists of 2 main cutting operations, notching (C) and making the felling cut (D).
Start making the upper notch cut (C) on the side of the tree facing the felling direction (E). Be sure you don t make the lower cut too deep into the trunk.
The notch (C) should be deep enough to create a hinge
(F)of sufficient width and strength. The notch should be wide enough to direct the fall of the tree for as long as possible.
WARNING: As the felling cut gets close to the
hinge, the tree should begin to fall. When tree begins to fall, remove saw from cut, stop engine, put chain saw down, and leave area along retreat path (Fig. 8).
GH
Fig. 10
11