Honda Power Equipment MM60 manual SET-UP and Assembly

Page 15

SET-UP AND ASSEMBLY

Installing Lift Rods

(For Tractors Without Rear Three Point Hitch)

1.Adjust the lift rod to 365 mm (14.4in) measured from eye to eye as illustrated.Adjustment is made by turning barrel of rod, then secured by tightening nut. Be sure that an equal length of threads shows on either end ,of barrel.

2.Slide eye of lift rod over pin on tractor lift arm. Positionclevis of lift rod between brackets on lift link. Note that outside leg of lift rod goes out- side of lift link as illustrated. Installwith greased 22 x 76 mm clevis pin with head on left side as shown. Secure both ends with 22 rnrn washers and linchpins.

NOTE: The eye of the lift rod is not straight. The curve should point to the inside of the tractor when properly installed.

I

 

365 mm

I

I

 

I

--------c'I

 

14.4 in.

 

y

 

I

(with loader subframe)

I.

I

I

I

Y

 

 

 

 

 

 

 

375 mm

y

 

 

 

 

 

 

14.8 in.

 

i 3

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Page Page To the Owner IntroductionGeneral INFORMATlON IntroductionContents Operate equipment Safety InformationPreparation Safety InformationBlock mower securely for storage Maintenance SafetyReplace immediately if damaged Safety InformationSET-UP and Assembly SET-UP and Assembly SET-UP and Assembly Point out safety features, shielding and optionsPre-Delivery Check List Dealer Responsibility Finish by tightening two 26 mm flange locknuts SET-UPAND AssemblyLift Unk SET-UP and Assembly ‘y85 mm With Three Point Subassembling Front Link Brackets Assemble both right and left bracketsMounting Front Link Bracket to.Tractor Installing Deck Hooks Installing MowerLevel the mower to assure proper cut. Mower Installing Front Anti-ScalpingRoller Installing MowerRemove level plug Add oil until it seeps out level plug hole Install both plugsAttaching Front Mower Links To Mower Side. Insert linchpin to lock~~~ Attaching Front Mower Links to Front Bracket Lift Arms Fasten to Mower Deck Detaching Mower from Tractor Joint Detaches From Mid-PTO Tor to 4-wheel drive position Switch off engine after moving tractor off mower. Set brakesOperation Operation PRE-OPERATION Check List Tours A small area Operating Your Mower with Other Equipment Installing Mower‘ by mower deck hook Install attachment as needed Owner Service Maintenance30W Oil Oil Level Plug Caster Pivot Hrs Caster Wheel Blade SpindlesDriveshaft U-joints Hrs Driveshaft Slip Joint Hrs Spring Take-up Pivot ArmBlade Inspection Blade Servicing Blade InstallationMaintenance Belt Assembly Maintenance Sleeve Bearing cone Housing and cups Cup Shaft Spindle assembly @Remove bearing cone from shaft Spindle AssemblyProper adjustment is attained T1I Yoke Journal cross Seal Snap ring Cup and bearings Universal Joint AssemblyAndhammer L11Remove gearbox from stand Gearbox MaintenanceGear Box Split taper bushing Drive pulley Gearbox stand Key Storage StorageTroubleshooting ProblemSolution Troubleshooting Specifications Owner Satisfaction Warranty Service
Top Page Image Contents