Honda Power Equipment MM60 manual Lift Arms Fasten to Mower Deck

Page 26

INSTALLING MOWER

Lift Arms Fasten to Mower Deck

LOADER

0.2in SUB FRAME

MOWER DECK STOP

1

Fastening Lift Arms to Mower Deck

1..Screw the eye bolt into the lift eye and adjust to 137 mm (5.4 in) length.

2.Attach the eye bolt to the mower brackets with a , clevis pin and secure it with a linchpin.

3.Pull down lift arm and align the oval hole of the lift joint in the clevis of the lift arm, insert a clevis pin and secure it with a linchpin.

4.Raise the mower slowly with the hydraulic position control to check for full travel with no interference.

5.Adjust lift joints so gauge wheels lift off the ground at the same time.

Checking Mower Lift With Loader Sub-Frame Installed

1 -		If you have a front loader sub
	frame installed, you must use the following
procedure to adjust the mower linkage to
avoid damage to the deck or linkage.			\

i/

1.Slowly move the Lift Selector Lever to the "UP" position to raise the deck. Immediately lower the deck at the first indication of resistance.

2.Check the clearance between the deck stops and the front loader sub frame. Adjust the clearance to 5 mm (0.20 in) by adjusting the left lift rod length (shorteningthe lift rod raises the deck).

The fully raised position of the deck will be lower than normal with the loader sub frame installed. You will only be able to raise the deck to a maxi- mum cutting height of 4 in.

24

Image 26

Contents Page Page Introduction To the OwnerIntroduction General INFORMATlONContents Safety Information Operate equipmentSafety Information PreparationMaintenance Safety Block mower securely for storageSafety Information Replace immediately if damagedSET-UP and Assembly SET-UP and Assembly Pre-Delivery Check List Dealer Responsibility SET-UP and AssemblyPoint out safety features, shielding and options SET-UPAND Assembly Finish by tightening two 26 mm flange locknutsLift Unk SET-UP and Assembly ‘y85 mm With Three Point Mounting Front Link Bracket to.Tractor Subassembling Front Link BracketsAssemble both right and left brackets Installing Mower Installing Deck HooksLevel the mower to assure proper cut. Mower Installing Mower Installing Front Anti-ScalpingRollerInstall both plugs Remove level plug Add oil until it seeps out level plug holeSide. Insert linchpin to lock Attaching Front Mower Links To Mower~~~ Attaching Front Mower Links to Front Bracket Lift Arms Fasten to Mower Deck Detaching Mower from Tractor Joint Detaches From Mid-PTO Switch off engine after moving tractor off mower. Set brakes Tor to 4-wheel drive positionOperation Operation PRE-OPERATION Check List Tours A small area Installing Mower Operating Your Mower with Other Equipment‘ by mower deck hook Install attachment as needed Maintenance Owner ServiceDriveshaft Slip Joint Hrs Spring Take-up Pivot Arm Caster Pivot Hrs Caster Wheel Blade SpindlesDriveshaft U-joints Hrs 30W Oil Oil Level PlugBlade Inspection Blade Installation Blade ServicingMaintenance Belt Assembly Maintenance Spindle assembly @ Sleeve Bearing cone Housing and cups Cup ShaftSpindle Assembly Remove bearing cone from shaftProper adjustment is attained T1I Universal Joint Assembly Yoke Journal cross Seal Snap ring Cup and bearingsL11 AndhammerGearbox Maintenance Remove gearbox from standGear Box Split taper bushing Drive pulley Gearbox stand Key Storage StorageSolution TroubleshootingProblem Troubleshooting Specifications Warranty Service Owner Satisfaction