Honda Power Equipment MM60 Side. Insert linchpin to lock, Attaching Front Mower Links To Mower

Page 23

INSTALLING MOWER

Attaching Front Mower Links To Mower

1.Screw the adjustable plate link onto the right and left front mower links. Adjust the plate link as shown in illustration, so that the straight line length is 450 mm (17.75 in). Face the plate link to the outside as shown and insert into the projecting brackets on the mower deck .

2.Install both right and left links. Secure with 16 mm greased clevis pin inserting pin from out-

side. Insert linchpin to lock.

Front Mower Links

INSTALLING MOWER TO TRACTOR

1.Adjust gauge wheels to lowest cutting position.

2.Chock right and left front wheels as shown.

3.Start the tractor and keep engine at low idling speed. Set the lift control lever to the "UP" position and keep the lift arm up.

Drive front wheels over the flat area of the pulley covers only! Avoid run- ning over gear box, drive shaft and rear links to prevent damaging them.

Front Wheels Chocked

2 1

Image 23

Contents Page Page To the Owner IntroductionGeneral INFORMATlON IntroductionContents Operate equipment Safety InformationPreparation Safety InformationBlock mower securely for storage Maintenance SafetyReplace immediately if damaged Safety InformationSET-UP and Assembly SET-UP and Assembly Pre-Delivery Check List Dealer Responsibility SET-UP and AssemblyPoint out safety features, shielding and options Finish by tightening two 26 mm flange locknuts SET-UPAND AssemblyLift Unk SET-UP and Assembly ‘y85 mm With Three Point Mounting Front Link Bracket to.Tractor Subassembling Front Link BracketsAssemble both right and left brackets Installing Deck Hooks Installing MowerLevel the mower to assure proper cut. Mower Installing Front Anti-ScalpingRoller Installing MowerRemove level plug Add oil until it seeps out level plug hole Install both plugsAttaching Front Mower Links To Mower Side. Insert linchpin to lock~~~ Attaching Front Mower Links to Front Bracket Lift Arms Fasten to Mower Deck Detaching Mower from Tractor Joint Detaches From Mid-PTO Tor to 4-wheel drive position Switch off engine after moving tractor off mower. Set brakesOperation Operation PRE-OPERATION Check List Tours A small area Operating Your Mower with Other Equipment Installing Mower‘ by mower deck hook Install attachment as needed Owner Service Maintenance30W Oil Oil Level Plug Caster Pivot Hrs Caster Wheel Blade SpindlesDriveshaft U-joints Hrs Driveshaft Slip Joint Hrs Spring Take-up Pivot ArmBlade Inspection Blade Servicing Blade InstallationMaintenance Belt Assembly Maintenance Sleeve Bearing cone Housing and cups Cup Shaft Spindle assembly @Remove bearing cone from shaft Spindle AssemblyProper adjustment is attained T1I Yoke Journal cross Seal Snap ring Cup and bearings Universal Joint AssemblyAndhammer L11Remove gearbox from stand Gearbox MaintenanceGear Box Split taper bushing Drive pulley Gearbox stand Key Storage StorageSolution TroubleshootingProblem Troubleshooting Specifications Owner Satisfaction Warranty Service