Honda Power Equipment MM60 manual L11, Andhammer

Page 50

MAINTENANCE

h

3.Clamp cup in vise as shown and tap on yoke to completely remove cup from yoke. Repeat steps two and three for opposite cup.

.

4. Place universal cross in vise as shown and tap

L11'

on yoke to remove cup. Repeat step three for

final removal. Drive remainingcup out with drift

 

.andhammer.

Assembly

1.Place seals securely on bearing cups. Insert cup into yoke from outside and press on with hand pressure as faras possible. Insert journal cross into bearing cup with grease fiiing away from shaft. Be careful not to disturb needle bearings. Insert another bearing cup directly across from first cup and press in as far as possiblewith hand pressure.

2.Trap cups in vise and apply pressure. Be sure journal cross is started into bearings and continue pressurewith vise, squeezing in as far as possible. Tap yoke to aid in process.

3.Seat cups by placing a drift (slightly smaller than the cup) on cup and rapping with ham- mer. Installsnap ring and repeat on opposite cup.

4.Repeat steps one and two to install remaining cups in remainingyoke.

5.Move both yokes in all directions to check for free movement. Should movement be re- stricted, rap on yokes sharply with a hammer to relieve any tension. Repeat until both yokes move in all directions without restriction.

48

Image 50
Contents Page Page Introduction To the OwnerIntroduction General INFORMATlONContents Safety Information Operate equipmentSafety Information PreparationMaintenance Safety Block mower securely for storageSafety Information Replace immediately if damagedSET-UP and Assembly SET-UP and Assembly Pre-Delivery Check List Dealer Responsibility SET-UP and AssemblyPoint out safety features, shielding and options SET-UPAND Assembly Finish by tightening two 26 mm flange locknutsLift Unk SET-UP and Assembly ‘y85 mm With Three Point Mounting Front Link Bracket to.Tractor Subassembling Front Link BracketsAssemble both right and left brackets Installing Mower Installing Deck HooksLevel the mower to assure proper cut. Mower Installing Mower Installing Front Anti-ScalpingRollerInstall both plugs Remove level plug Add oil until it seeps out level plug holeSide. Insert linchpin to lock Attaching Front Mower Links To Mower~~~ Attaching Front Mower Links to Front Bracket Lift Arms Fasten to Mower Deck Detaching Mower from Tractor Joint Detaches From Mid-PTO Switch off engine after moving tractor off mower. Set brakes Tor to 4-wheel drive positionOperation Operation PRE-OPERATION Check List Tours A small area Installing Mower Operating Your Mower with Other Equipment‘ by mower deck hook Install attachment as needed Maintenance Owner ServiceDriveshaft Slip Joint Hrs Spring Take-up Pivot Arm Caster Pivot Hrs Caster Wheel Blade SpindlesDriveshaft U-joints Hrs 30W Oil Oil Level PlugBlade Inspection Blade Installation Blade ServicingMaintenance Belt Assembly Maintenance Spindle assembly @ Sleeve Bearing cone Housing and cups Cup ShaftSpindle Assembly Remove bearing cone from shaftProper adjustment is attained T1I Universal Joint Assembly Yoke Journal cross Seal Snap ring Cup and bearingsL11 AndhammerGearbox Maintenance Remove gearbox from standGear Box Split taper bushing Drive pulley Gearbox stand Key Storage StorageSolution TroubleshootingProblem Troubleshooting Specifications Warranty Service Owner Satisfaction