Honda Power Equipment MM60 manual Joint Detaches From Mid-PTO

Page 28

INSTALLING MOWER

&joint Detaches From Mid-PTO

Ufl Arm

Lift Arms Fasten to Mower Deck

Detaching Mid-PTO and Mower Drive Shaft

1,.With engine off, PTO selector set to "REAR" and key removed, reach under tractor and grasp the locking collar of the U-joint of the mower drive shaft.

2.Pull locking collar back (toward front of tractor) to release spline of Mid-PTO. Pull the U-joint away from the PTO, towards the mower to remove.

NOTE: If the locking collar is difficult to release, turning it clockwise and counterclockwisewill help free it.

3.Make sure that U-joint is placedwhere it will not be crushed by tractor tires when tractor is backed over pulley covers.

Detaching Lift Joints

! 1 -Keep fingers clear of brackets

when pulling pins as mower deck may drop slightly.

1.Pull pins attaching lift joints to.lift plates brack- ets as illustrated.

NOTE: If hydraulic lift system is not fully down, pins may be under tension and mower deck may descend slightly. Make sure to keep fingers clear.

2.After detaching, temporarily replace clevis pins in brackets and secure with cotter pins to keep from losing or misplacing them. The lift joints should remain attached to the mower, not the lift arms.

26

Image 28

Contents Page Page Introduction To the OwnerIntroduction General INFORMATlONContents Safety Information Operate equipmentSafety Information PreparationMaintenance Safety Block mower securely for storageSafety Information Replace immediately if damagedSET-UP and Assembly SET-UP and Assembly Point out safety features, shielding and options SET-UP and AssemblyPre-Delivery Check List Dealer Responsibility SET-UPAND Assembly Finish by tightening two 26 mm flange locknutsLift Unk SET-UP and Assembly ‘y85 mm With Three Point Assemble both right and left brackets Subassembling Front Link BracketsMounting Front Link Bracket to.Tractor Installing Mower Installing Deck HooksLevel the mower to assure proper cut. Mower Installing Mower Installing Front Anti-ScalpingRollerInstall both plugs Remove level plug Add oil until it seeps out level plug holeSide. Insert linchpin to lock Attaching Front Mower Links To Mower~~~ Attaching Front Mower Links to Front Bracket Lift Arms Fasten to Mower Deck Detaching Mower from Tractor Joint Detaches From Mid-PTO Switch off engine after moving tractor off mower. Set brakes Tor to 4-wheel drive positionOperation Operation PRE-OPERATION Check List Tours A small area Installing Mower Operating Your Mower with Other Equipment‘ by mower deck hook Install attachment as needed Maintenance Owner ServiceCaster Pivot Hrs Caster Wheel Blade Spindles Driveshaft U-joints HrsDriveshaft Slip Joint Hrs Spring Take-up Pivot Arm 30W Oil Oil Level PlugBlade Inspection Blade Installation Blade ServicingMaintenance Belt Assembly Maintenance Spindle assembly @ Sleeve Bearing cone Housing and cups Cup ShaftSpindle Assembly Remove bearing cone from shaftProper adjustment is attained T1I Universal Joint Assembly Yoke Journal cross Seal Snap ring Cup and bearingsL11 AndhammerGearbox Maintenance Remove gearbox from standGear Box Split taper bushing Drive pulley Gearbox stand Key Storage StorageProblem TroubleshootingSolution Troubleshooting Specifications Warranty Service Owner Satisfaction