Honda Power Equipment MM60 manual Operation

Page 31

OPERATION

ADJUSTING CUTTING HEIGHT

Mower cutting height is raised, lowered, and maintainedby adjusting caster and gauge wheels. Refer to figure and accompanying chart for ap- proximate cutting heights.

Raise mower with tractor hydraulicsto adjust gauge and caster wheels.

It is important that all three adjustments be the same. To set cutting height, match numbers shown in illustration. (Example: hole 2 in caster adjustment with hole 2 in gauge wheel adjustment, etc.)

1 - Avoid very low cutting heights.

Striking the ground with blades gives one of the most damaging shock loads a mower can encounter and, if this occurs repeatedly, it will cause damage to mower and drive.

Approximate
Cutting Height	Position

1-1/2 in.	1
2-1/8 in.	2
2-3/4 in.	3
3-3/8 in.	4
4in.	5

2 9

I

Image 31

Contents Page Page To the Owner IntroductionGeneral INFORMATlON IntroductionContents Operate equipment Safety InformationPreparation Safety InformationBlock mower securely for storage Maintenance SafetyReplace immediately if damaged Safety InformationSET-UP and Assembly SET-UP and Assembly Point out safety features, shielding and options SET-UP and AssemblyPre-Delivery Check List Dealer Responsibility Finish by tightening two 26 mm flange locknuts SET-UPAND AssemblyLift Unk SET-UP and Assembly ‘y85 mm With Three Point Assemble both right and left brackets Subassembling Front Link BracketsMounting Front Link Bracket to.Tractor Installing Deck Hooks Installing MowerLevel the mower to assure proper cut. Mower Installing Front Anti-ScalpingRoller Installing MowerRemove level plug Add oil until it seeps out level plug hole Install both plugsAttaching Front Mower Links To Mower Side. Insert linchpin to lock~~~ Attaching Front Mower Links to Front Bracket Lift Arms Fasten to Mower Deck Detaching Mower from Tractor Joint Detaches From Mid-PTO Tor to 4-wheel drive position Switch off engine after moving tractor off mower. Set brakesOperation Operation PRE-OPERATION Check List Tours A small area Operating Your Mower with Other Equipment Installing Mower‘ by mower deck hook Install attachment as needed Owner Service Maintenance30W Oil Oil Level Plug Caster Pivot Hrs Caster Wheel Blade SpindlesDriveshaft U-joints Hrs Driveshaft Slip Joint Hrs Spring Take-up Pivot ArmBlade Inspection Blade Servicing Blade InstallationMaintenance Belt Assembly Maintenance Sleeve Bearing cone Housing and cups Cup Shaft Spindle assembly @Remove bearing cone from shaft Spindle AssemblyProper adjustment is attained T1I Yoke Journal cross Seal Snap ring Cup and bearings Universal Joint AssemblyAndhammer L11Remove gearbox from stand Gearbox MaintenanceGear Box Split taper bushing Drive pulley Gearbox stand Key Storage StorageProblem TroubleshootingSolution Troubleshooting Specifications Owner Satisfaction Warranty Service