Honda Power Equipment MM60 manual Install attachment as needed

Page 37

INSTALLING MOWER

Using Rear Three Point Hitch with Mower

Detached While the Mower Lift Linkage is

Still Installed

1: Detach mower as described below.

2.Start engine and set Lift Control Lever on "UP" to raise lift arms to maximum position. Turn off engine, turn Lowering Speed Control fully clockwise to lock hydraulic system and set brakes.

NOTE: Block the lift plate to its full UP position.

3.Pull pin from projecting bracket at top of left hand lift rod, and remove as illustratedto release lift chain. Hold chain so that it does not fall.

4.Attach lift chain to projecting chain rest pin on the Roll Over Protection System. Secure with washer and cotter pin. MAKE SURE TO RE-

TAIN CLEVIS PIN IN SAFE PLACE TO BE ABLE TO RE-ATTACH CHAIN TO.LIFTROD.

5.Install attachment as needed.

35

Image 37

Contents Page Page To the Owner IntroductionGeneral INFORMATlON IntroductionContents Operate equipment Safety InformationPreparation Safety InformationBlock mower securely for storage Maintenance SafetyReplace immediately if damaged Safety InformationSET-UP and Assembly SET-UP and Assembly Point out safety features, shielding and options SET-UP and AssemblyPre-Delivery Check List Dealer Responsibility Finish by tightening two 26 mm flange locknuts SET-UPAND AssemblyLift Unk SET-UP and Assembly ‘y85 mm With Three Point Assemble both right and left brackets Subassembling Front Link BracketsMounting Front Link Bracket to.Tractor Installing Deck Hooks Installing MowerLevel the mower to assure proper cut. Mower Installing Front Anti-ScalpingRoller Installing MowerRemove level plug Add oil until it seeps out level plug hole Install both plugsAttaching Front Mower Links To Mower Side. Insert linchpin to lock~~~ Attaching Front Mower Links to Front Bracket Lift Arms Fasten to Mower Deck Detaching Mower from Tractor Joint Detaches From Mid-PTO Tor to 4-wheel drive position Switch off engine after moving tractor off mower. Set brakesOperation Operation PRE-OPERATION Check List Tours A small area Operating Your Mower with Other Equipment Installing Mower‘ by mower deck hook Install attachment as needed Owner Service MaintenanceDriveshaft U-joints Hrs Caster Pivot Hrs Caster Wheel Blade SpindlesDriveshaft Slip Joint Hrs Spring Take-up Pivot Arm 30W Oil Oil Level PlugBlade Inspection Blade Servicing Blade InstallationMaintenance Belt Assembly Maintenance Sleeve Bearing cone Housing and cups Cup Shaft Spindle assembly @Remove bearing cone from shaft Spindle AssemblyProper adjustment is attained T1I Yoke Journal cross Seal Snap ring Cup and bearings Universal Joint AssemblyAndhammer L11Remove gearbox from stand Gearbox MaintenanceGear Box Split taper bushing Drive pulley Gearbox stand Key Storage StorageProblem TroubleshootingSolution Troubleshooting Specifications Owner Satisfaction Warranty Service