Honda Power Equipment MM60 manual Maintenance

Page 42

MAINTENANCE

MAINTAIN/ CORNER FOLLOW ORIGINAL ,PATTERN

Blade Sharpening

! a .		Your dealer can supply genuine

replacement blades. Substitute blades may not meet original equipment specifications and may be dangerous.

Blade Sharpening

1.Remove blades.

2.Always sharpen both ends at the same time to maintain balance. Follow original sharpening pattern. Do not sharpen blade to a razor edge. Leave from 1/32 in. to 1/1 6 in. blunt edge. Do not sharpen the back side of the blade.

1- When sharpening blades be sure to balance them. Unbalanced blades will cause excessive vibration which can damage blade spindle bearings. Vibration may also cause structural cracks in mower components.

40

Image 42

Contents Page Page Introduction To the OwnerIntroduction General INFORMATlONContents Safety Information Operate equipmentSafety Information PreparationMaintenance Safety Block mower securely for storageSafety Information Replace immediately if damagedSET-UP and Assembly SET-UP and Assembly SET-UP and Assembly Point out safety features, shielding and optionsPre-Delivery Check List Dealer Responsibility SET-UPAND Assembly Finish by tightening two 26 mm flange locknutsLift Unk SET-UP and Assembly ‘y85 mm With Three Point Subassembling Front Link Brackets Assemble both right and left bracketsMounting Front Link Bracket to.Tractor Installing Mower Installing Deck HooksLevel the mower to assure proper cut. Mower Installing Mower Installing Front Anti-ScalpingRollerInstall both plugs Remove level plug Add oil until it seeps out level plug holeSide. Insert linchpin to lock Attaching Front Mower Links To Mower~~~ Attaching Front Mower Links to Front Bracket Lift Arms Fasten to Mower Deck Detaching Mower from Tractor Joint Detaches From Mid-PTO Switch off engine after moving tractor off mower. Set brakes Tor to 4-wheel drive positionOperation Operation PRE-OPERATION Check List Tours A small area Installing Mower Operating Your Mower with Other Equipment‘ by mower deck hook Install attachment as needed Maintenance Owner ServiceDriveshaft Slip Joint Hrs Spring Take-up Pivot Arm Caster Pivot Hrs Caster Wheel Blade SpindlesDriveshaft U-joints Hrs 30W Oil Oil Level PlugBlade Inspection Blade Installation Blade ServicingMaintenance Belt Assembly Maintenance Spindle assembly @ Sleeve Bearing cone Housing and cups Cup ShaftSpindle Assembly Remove bearing cone from shaftProper adjustment is attained T1I Universal Joint Assembly Yoke Journal cross Seal Snap ring Cup and bearingsL11 AndhammerGearbox Maintenance Remove gearbox from standGear Box Split taper bushing Drive pulley Gearbox stand Key Storage StorageTroubleshooting ProblemSolution Troubleshooting Specifications Warranty Service Owner Satisfaction