Honda Power Equipment MM60 manual Troubleshooting, Problem, Solution

Page 55

TROUBLESHOOTING

PROBLEM

1.Mower overloading; material too tall or heavy

2.Oil on belt from over-lubrication

3.Belt hung up or rubbing

4.Belt or pulleys worn out

~~~

~

~

1, Belt misalianed- or rubbing guide

1.Damaaed- belt

2.Worn pulley groove

1.Rollover, high shock loads or installation damage

1.High shock loads

2.Belt came off driie

I

SOLUTION

1.Reduce tractor speed but operate Mid-PTO at 2400 rpm. Cut material twice: one high pass, then mow at desired height, Cut a partial swath.

2.Be careful not to over-lubricate.Clean lubricant from belt and pulleys with clean rag. Replace oil-soaked belt.

3.Check belt for free travel in pulleys and belt guides. Check under mower and around blade spindle shafts for wire, rags or other foreign ma- terial. Clean all material from under mower.

4.If belt rides in bottom of pulley groove, either . . belt or pulley is worn and must be replaced.

1.Re-align belt or guide. Be sure belt doesn't rub any other part while running.

1.Lay belt flat on floor. If belt does not lie flat (has humps or twists), indicating broken or stretched cords, it must be replaced.

2.Replace pulley.

1.Replace belt.

1.Avoid abusive mowing. Avoid hitting the ground or obstructions.

2.Check driie alignment for foreign material in grooves. Avoid hitting solid objects or ground.

53

Image 55

Contents Page Page To the Owner IntroductionGeneral INFORMATlON IntroductionContents Operate equipment Safety InformationPreparation Safety InformationBlock mower securely for storage Maintenance SafetyReplace immediately if damaged Safety InformationSET-UP and Assembly SET-UP and Assembly Point out safety features, shielding and options SET-UP and AssemblyPre-Delivery Check List Dealer Responsibility Finish by tightening two 26 mm flange locknuts SET-UPAND AssemblyLift Unk SET-UP and Assembly ‘y85 mm With Three Point Assemble both right and left brackets Subassembling Front Link BracketsMounting Front Link Bracket to.Tractor Installing Deck Hooks Installing MowerLevel the mower to assure proper cut. Mower Installing Front Anti-ScalpingRoller Installing MowerRemove level plug Add oil until it seeps out level plug hole Install both plugsAttaching Front Mower Links To Mower Side. Insert linchpin to lock~~~ Attaching Front Mower Links to Front Bracket Lift Arms Fasten to Mower Deck Detaching Mower from Tractor Joint Detaches From Mid-PTO Tor to 4-wheel drive position Switch off engine after moving tractor off mower. Set brakesOperation Operation PRE-OPERATION Check List Tours A small area Operating Your Mower with Other Equipment Installing Mower‘ by mower deck hook Install attachment as needed Owner Service Maintenance30W Oil Oil Level Plug Caster Pivot Hrs Caster Wheel Blade SpindlesDriveshaft U-joints Hrs Driveshaft Slip Joint Hrs Spring Take-up Pivot ArmBlade Inspection Blade Servicing Blade InstallationMaintenance Belt Assembly Maintenance Sleeve Bearing cone Housing and cups Cup Shaft Spindle assembly @Remove bearing cone from shaft Spindle AssemblyProper adjustment is attained T1I Yoke Journal cross Seal Snap ring Cup and bearings Universal Joint AssemblyAndhammer L11Remove gearbox from stand Gearbox MaintenanceGear Box Split taper bushing Drive pulley Gearbox stand Key Storage StorageProblem TroubleshootingSolution Troubleshooting Specifications Owner Satisfaction Warranty Service