Honda Power Equipment MM60 Spindle assembly @, Sleeve Bearing cone Housing and cups Cup Shaft

Page 45

MAINTENANCE

SPINDLE REPAIR

Blade Spindle Removal

1.Remove blade from spindle. (See Blade Re- moval on Page 39.)

2.Remove belt shield.

3.Remove belt from pulleys.

4.Remove bolt and flat washer from top of spindle shaft.

5.Disassemble split taper bushing (located on top of pulley) by removing the two bolts and insert- ing them into the threaded holes in bushing flange. Tighten bolts alternately to remove split taper bushing. Remove pulley.

6.Removethree bolts attaching spindle to mower frame and remove spindle.

Spindle Repair Tips

1.As a reference point, the top of spindle housing is the short portion.

2.To minimize wear, bearing cups, cones and sleeves are press fit to shaft and will require a press or similar device for removal.

3.When disassembling, support housing casting to prevent damage.

4.Remove bearing cups by placing a punch in housing slots and drive cup out. Alternate punch positions from side to side. Use care to prevent housing damage.

5.Bore-tite" sealant is used on the outer diameter of the seals. Substitute seals may not meet original equipment specifications and could cause leakage.

Bore-ttte is a registered trademarkof Chicago Rawhide Industries.

5 -

1.Spindle assembly @//-.

2.seal

3.Sleeve

4.Bearing cone

5.Housing and cups

6.Cup

7.Shaft

Spindle Assembly

-1

43

Image 45

Contents Page Page To the Owner IntroductionGeneral INFORMATlON IntroductionContents Operate equipment Safety InformationPreparation Safety InformationBlock mower securely for storage Maintenance SafetyReplace immediately if damaged Safety InformationSET-UP and Assembly SET-UP and Assembly SET-UP and Assembly Point out safety features, shielding and optionsPre-Delivery Check List Dealer Responsibility Finish by tightening two 26 mm flange locknuts SET-UPAND AssemblyLift Unk SET-UP and Assembly ‘y85 mm With Three Point Subassembling Front Link Brackets Assemble both right and left bracketsMounting Front Link Bracket to.Tractor Installing Deck Hooks Installing MowerLevel the mower to assure proper cut. Mower Installing Front Anti-ScalpingRoller Installing MowerRemove level plug Add oil until it seeps out level plug hole Install both plugsAttaching Front Mower Links To Mower Side. Insert linchpin to lock~~~ Attaching Front Mower Links to Front Bracket Lift Arms Fasten to Mower Deck Detaching Mower from Tractor Joint Detaches From Mid-PTO Tor to 4-wheel drive position Switch off engine after moving tractor off mower. Set brakesOperation Operation PRE-OPERATION Check List Tours A small area Operating Your Mower with Other Equipment Installing Mower‘ by mower deck hook Install attachment as needed Owner Service MaintenanceDriveshaft U-joints Hrs Caster Pivot Hrs Caster Wheel Blade SpindlesDriveshaft Slip Joint Hrs Spring Take-up Pivot Arm 30W Oil Oil Level PlugBlade Inspection Blade Servicing Blade InstallationMaintenance Belt Assembly Maintenance Sleeve Bearing cone Housing and cups Cup Shaft Spindle assembly @Remove bearing cone from shaft Spindle AssemblyProper adjustment is attained T1I Yoke Journal cross Seal Snap ring Cup and bearings Universal Joint AssemblyAndhammer L11Remove gearbox from stand Gearbox MaintenanceGear Box Split taper bushing Drive pulley Gearbox stand Key Storage StorageTroubleshooting ProblemSolution Troubleshooting Specifications Owner Satisfaction Warranty Service