Honda Power Equipment MM60 manual Subassembling Front Link Brackets

SET-UP AND ASSEMBLY

Subassembling Front Link Brackets

Assemble by compressing the front spring and inserting it in the front bracket slot. Pass greased front quick release pin through hole in the front bracket and spring. Pull back spring slightly to uncover hole in quick release pin. Use hammer to tap in spring pin until it is equidistant from both sides of quick release pin.

NOTE: Hold back bottom of spring so that pin clears it.

Assemble both right and left brackets.

Front Link Bracket

Mounting Front Link Bracket to.Tractor

1. From bottom, slip the assembled front mount- ing bracket up onto the front frame rails.

2. Insert 8 flange bolts 12 mm x 30 mm. Tighten all to 6 kg-m (43 ft-lb).

NOTE: With pins correctly installed, they will face rearward and downward when front link bracket is installed on the tractor.

Front Link Bracket

Assembling Rear Link Bracket

Insert the greased rear quick release pin in the mounting bracket attached to the tractor frame. It is located beneath the tractor along the mid-line as illustrated. Pass the long arm of the quick release pin through the lower hole in the bracket and the spring. Compress the spring and.slide washer over hole in arm. Secure with split pin, spreading legs of split pin. Assemble both right and left brackets.

Rear Link Brackef

16