INNER SHOE WELDMENT REPLACEMENT
6.If the Back Plate has been removed from the carriage arm, it will have to be reset after the reassembly is done. See the Pitch adjustment in previous instruction (See Figure 4). The adjustment to the cutter bar should be check and reset if required after reassembly.
7.Before beginning the reassembly read this section as well as the section that pertains to the component listed below. This is important that these components be assembled correctly as well as adjusted properly. The assembly of the skid shoe weldment, replacement of the Rotor Actuator, Drive Assembly, Cutter Bar, Skid Shoe and Drive Assembly Cover will be reinstalled by reversing the disassembly instructions. (See Figure 10 thru 21)
Rubber Bumper
3/8" Bolts
Pad
Back Pivot
3/8" Lockwashers
PlateRotor Actuator Retaining Pin
Shoe
Weldment
Rotor Actuator
Figure 21
Rotor Actuator Mounting Bolts
Figure 22
Drive Stud Bearing Asy
Nylon Bearing
Clamp & Clamp Bolt
Knife Head Weldment
Blade Section
Knife Backing Strip
Figure 23
Switch Blade
© 2005 Alamo Group Inc. | Section 7 - 10 |