Pump / Driveshaft Schematic - 5425 & 5525
Coupling Flange, P/N 0062000 ( 3/4" Bore w/ 3/16" keyway, 1/4" setscrew )
Tractor Engine Pulley
Pulley Adapter, P/N 02973992
Use Existing Bolt & Lockwasher
From Crankshaft Pulley
( 4 ea.)
3/4" w/ 3/16" Keyway | 7/8" X 13 Spline | |||
Flange Mounting Bolts |
|
| Hub | |
|
| Bolts, P/N 02976344 | ||
& Locknuts (4 ea.) | Drive Shaft, 3/4" w/ 3/16" | Lockwasher, P/N 00022200 | ||
( Included W/ Center Coupling ) Keyway X 7/8" w/ 13 spline | Hub, P/N 02702900 | |||
| P/N 02982530 |
| ||
Bolts, P/N 00023100 | Flange, P/N 02974359 |
| Center Coupling, w/ Nut & Bolt Set | |
( 5/8" Bore w/ 9 Spline ) | ( Set Of 4 Bolts) | |||
Lockwasher P/N 00012101 | ||||
Locknuts, P/N 00015800 |
|
|
| |
Pump Assembly |
| Pump Mount, P/N 02979436 | ||
Bolts, P/N 02975692 | ||||
|
| |||
| Lockwasher, P/N 02971158 |
| ||
Pump Drive Schematic:2323456
This Section covers the installation of Pump Drive Components, Pump Assembly Some precautions that must be followed during the Assembly Process before unit is ever started for the first time.234234
NOTE: Shown above is the pump - drive component schematic. There are some items from the tractor that will be reused and some items that are only available as an assembly. The tractor from the manufacturer has a thin spacer bolter to the crankshaft pulley, remove this spacer and reinstall the spacer from Alamo Industrial using the same four bolts that mounted the tractor factory spacer.
Switch Blade
© 2005 Alamo Group Inc. | Section 3 - |