Alamo JD-5525, JD-5425, JD-5225, JD-5205, JD-5105, JD-5325 Carriage Arm Pivot Pin Tank Mounting Bolts

Frame Installation

7.Cutter Head Assembly. The Cutter head Assembly is shipped completely assembled with the Skid Shoe, Actuator Pre-Assembly, Carriage Arm, Hydraulic Cylinders, Hydraulic Motor, Drive Assembly, Motor Cover and Cutter Bar Assem- bly attached (See Figure 4). To mount this the carriage Arm (See Figure 5) which has the Car- riage Arm Mounting pin installed in it when shipped will have to have the pin removed (See Figure 4 pin is removed).

8. Install Cutter Bar Head Assembly Using

an over head hoist lift and slide the cutter bar assembly into place until the carriage arm is in alignment with the sub-frame (See Figure 1 ) mounting holes. Insert the carriage arm mount- ing pin (See Figure 5, 6 & 7) and the two retain- ing bolts and nuts that were in the retaining pin when it was removed from the carriage arm.

9.Install The Hydraulic Tank Assembly. The hydraulic tank is shipped as an assembly with the filter and directional solenoid valve attached to it. The Hydraulic tank will bolt to the frame (See Item 4 Figure 1) with 4 bolts, lockwashers and Nuts (See Figure 1 & 7)

10.Make Certain Bolts are Tightened. Make certain that the mounting bolts so far are tight.

Figure 6

Figure 4

Carriage Arm Pin

Figure 5 Carriage Arm Asy

Carriage

Arm Pivot

Pin

	Tank
	Mounting
	Bolts
Figure 7

Switch Blade (JD-5105-5205-5225-5325-5425-5525, Asy. Man) 05/05

© 2005 Alamo Group Inc. Section 4 - 4