3 - 18 ONline Ethernet 10BASE-FB Module Installati on a n d Operation Guide
The 10BASE-FB Module-Switching Module can be set to high o r normal
power through the dip switches (see Table 3-4).
Saving Module Configuration
To save the module and port se ttings to management module mem ory, use
the following command:
SAVE MODULE_PORT
Showing Module ConfigurationYou can display status information about the 10BASE-FB Modules using the
following commands:
❑SHOW MODULE
❑SHOW MODULE VERBOSE
❑SHOW PORT
❑SHOW PORT VERBOSE
For example, the following command displa ys detailed information about
port 1 on the Port-Switching 10BASE-FB Modu le in slot 8 of the
concentrator.
ONline> show port 8.1 verbose [ENTER]
Port Display for Module 5104M-FBP:
Port Mode Status Network General Information
__________________ ___________________ ___________________ _____
08.01 ENABLED OKAY ETHERNET_2
Network Dip Setting: ETHERNET_2
Mode Dip Setting: ENABLED
Low Light Warning: ENABLED
Low Light Warning Dip Setting: ENABLED
High Power Optics: ENABLED
High Power Optics Dip Setting: DISABLED