Quick Installation
Table
Table 3-1. Quick Installation Procedures
Step | Procedure | Section Title |
|
|
|
1 | Verify that your network complies with | Chapter 2, |
| the basic rules for network design. | Designing and |
|
| Expanding the |
|
| Network |
|
|
|
2 | Unpack the module. | Unpacking |
|
| Procedures |
|
|
|
3 | If you do not have a management module | Setting the Dip |
| installed in the concentrator, configure the | Switches |
| dip switch settings to your specifications. |
|
|
|
|
4 | Insert the module into a blank slot in the | Installing the |
| concentrator and tighten the faceplate | Module |
| screws. |
|
|
|
|
5 | Establish connections from the | Installing the |
| Module to another | Module |
|
| |
| appropriate connectors and cabling. |
|
|
|
|
6 | If you have a management module | Configuring the |
| installed in the concentrator, configure the | Module |
| module using the management |
|
| commands. |
|
|
|
|
7 | Verify LED status for normal operation. | Verifying LED and |
| Note: To correct problems, consult the | Network |
| troubleshooting techniques in Chapter 4. | Assignments |
|
|
|
3 - 4 ONline Ethernet
