Link the Workstation to the R3000IR

The procedures outlined in this sub-section require the use of the CAT-5E crossover cable.

A.Plug one end of the CAT-5E crossover cable into the R3000IR’s LAN 2 port.

NOTE: When facing the rear of the chassis, the LAN 2 port is the port on the right.

Portion of MSA chassis rear

B.Plug the other end of the CAT-5E crossover cable into the setup workstation’s net- work card.

NOTE: If you have a CAT-5E coupler, this can be used if the crossover cable is not long enough for your setup. Plug one end of the CAT-5E crossover cable into the R3000, and the other end into the coupler. Plug a standard CAT-5E cable into the other end of the coupler, and the free end of the standard CAT-5E cable into the setup workstation.

C. Plug the R3000IR into a power source with an appropriate rating.

WARNING: It is strongly suggested you use an uninterruptible power supply.

D.Power on the R3000IR by lowering the face plate and pressing the large button at the right of the front panel (see diagram below):

Diagram of MSA chassis front panel, power button at far right

30

8e6 R3000IR Quick Start Guide

Page 33 Page 35
Page 34
Image 34
8e6 Technologies quick start Link the Workstation to the R3000IR
Page 33 Page 35
Top Page Image Contents